fbhpc pin, collar & spring installation instructions
TRANSCRIPT
©2011 Fesler Productions, LLC dba Fesler Billet
INSTALLATION
INSTRUCTIONS
FBHPC-CAM
Hood Pin & Collar w/ spring
Installation Instructions:
1. Loosen the stock jamb nut and remove the stock hood pin.
Please note that on some applications, it may be necessary
to remove the entire latch assembly in order to access the
jamb nut.
2. Insert the new stainless steel pin into the provided spring cup.
The hood pin will be recessed in this spring cup.
3. Install the hood pin to the latch assembly. Depending on your
application, it may be necessary for you to re-install the latch
assembly at this point.
4. Next adjust the length of the hood pin to properly secure your
hood when in the locked or down position. This is
accomplished by tightening or loosening the pin to achieve
the proper length.
4. After hood latch pin length is adjusted it may be necessary to
remove the entire hood latch assembly to tighten the jamb nut
(securing the hood pin) on the back side of the latch
assembly. This will lock the pin in place at the prescribed
length.
5. Re-install the latch assembly (if necessary) according to step
#3.