Important Technical Information:

Fesler Billet makes every effort to ensure that you are provided with the most

accurate and up-to-date technical information. However, all technical

information is approximate and may vary upon application. Fesler Billet is not

responsible for any consequences resulting from manufacture’s technical mid-

year changes. Fesler Billet products should only be installed by a qualified,

licensed auto mechanic experienced in the installation of such products.

Important Anodizing Information:

Anodizing does not produce "flawless" color or finish on any Fesler part order

that way. In fact, you should expect to encounter minor variations (or what

some call "blemishes") in the color and finish in individual pieces. Every Fesler

finish is unique in this regard. Remember, these variations are normal, and do

not affect the performance of the part in any way.

Other Important Stuff You Should Probably Read:

Fesler Billet is not responsible for customer applications that are outside the

normal and intended use of our products, including specific model and year

applications.

Fesler Billet designs all parts off original OEM applications. Due to the vast

array of manufacturers for aftermarket parts, it is possible that you may have to

make some minor adjustments to either our part or your sheet metal in order

for the part to fit properly.

QUESTIONS OR COMMENTS?

Call us at 1-866-583-9787

INSTALLATION INSTRUCTIONS

FBTHG-66NOVA

Trunk Hinges

1966 - 1967 Chevrolet Nova

INSTALLATION INSTRUCTIONS

1966-1967 Chevrolet Nova Trunk Hinges Copyright 2011 © by Fesler Productions, LLC. All rights reserved.

Instructions:

1. Remove bolts retaining trunk lid and remove trunk lid

2. Remove trunk hinge springs. (Using vise grips or pliers will be helpful)

Each side has hooks on the body that the spring is locked

into.

3. Grind or drill the head of the hinge pivot pin off and remove the stock

trunk hinges.

3. Bend hinge pin retainer to release pin.

4. Using the provided ¼-20 x 1 bolts, flat

washers and nuts, mount the strut

bracket to the trunk divider.

a. There are two holes just

above the upper back seat

hooks on each side of the car.

These two holes will be used

for mounting the strut bracket.

The ball studs will be facing

the center of the trunk.

5. Using a drill bit or an awl, mark the third

mounting hole. This hole will be used to mount

the bracket to the package tray.

6. Remove the bracket and drill the hole through the package tray.

7. Re-install the strut bracket and tighten

the three bolt.

8. Install the trunk hinge with the ball stud pointing towards the outside of

the body using the supplied hinge pin and e-clip.

9. Rotate the strut rod so the ball sockets are opposite of each other.

10. Install the struts. The strut body will be mounted to the strut bracket and the rod end will be mounted to the hinge. Install the strut retaining clips.

11. Re-install the trunk lied and align it to the body using the supplied

5/16” button head bolts and aluminum washers.