12V/24V

FDC-L10 INPUTOUTPUTSIGNAL

DC 12V,12V LED Max.50W,DC 0 - 10V or DC 1 - 10V DIMMER

DC 24V24V LED Max.100W

DC 0/1 - 10V LED INTERFACE

80 mm(3 3/16”)

DC 12V

DC 24VFDC-L10

DC 12V LED Max.50W

DC 24V LED Max.100W

INPUT OUTPUT

1 9/16”(40 mm)

11/16”(17 mm)

Max.25/32”(20mm)

Max.25/32”(20 mm)

Min.1/32”(1 mm)

Max.1/2”(42 mm)

WARNING

CAUTION- RISK OF FIRE (ATTENTION – RISQUE D’INCENDIE)- INHERENTLY PROTECTED (PROTECTION INHÉRENTE)- USE ONLY WITH CLASS 2 POWER UNIT (UTILISER SEULEMENT AVEC LA CLASSE 2 BLOC D’ALIMENTATION)- SUITABLE FOR DAMP LOCATIONS (CONVIENT AUX EMPLACEMENTS HUMIDES)- SUITABLE FOR UNDER-CABINET MOUNT (PEUT ÊTRE FIXÉ SOUS UNE ARMOIRE)- LED light may be bright and intense enough to cause injury to human eyes. The customer should never look directly into the LED light.

Head Office : 624-8, Seogu-ri, Gwangjeok-myeon,Yangju-si, Gyeonggi-do, Korea (www.feelux.com)

U.S.A Office : 3000 Northwoods Parkway, Suite115 Norcross, GA 30071 U.S.A (www.feelux.com)

FDC-L10DC 0/1 - 10V LED INTERFACE

FDC-L10

This type of electronic interface is an exclusively designed for dimming 12V/24V LED Lamps. With Pulse Width Modulators (PWM)technology, it is suitable for constant voltage (12V/24V) lamps with connected in parallel. It have short circuit protection, abnormalover current protection, after protection must cut off the power, and check-up the load, make sure the load is in rating load, thenconnect the power, the interface will be right. And it also has input polarity reverse protection.

LED INTERFACEFDC-L10 INPUT

OUTPUTSIGNAL

DC 12V,12V LED Max.50W,DC 0 - 10V or DC 1 - 10V DIMMER

DC 24V24V LED Max.100W

LED INTERFACE

LEDCONVERTER

WIRE STRIP24-18AWG

(0.3-0.75 ㎟) WIRE STRIP24-18AWG

(0.3-0.75 ㎟)LED CONVERTER

0/1-10V DIMMERLED LAMP

0/1-10VDIMMER

LED LAMP

LED INTERFACEFDC-L10

This type of electronic interface is an exclusively designed for dimming 12V/24V LED Lamps. With Pulse Width Modulators (PWM)technology, it is suitable for constant voltage (12V/24V) lamps with connected in parallel. It have short circuit protection, abnormalover current protection, after protection must cut off the power, and check-up the load, make sure the load is in rating load, thenconnect the power, the interface will be right. And it also has input polarity reverse protection.

DIP Switch Mode Setting

ON

1 2

If you will use DC 0-10V signal dimmer, Please No.1 set “OFF mode”.If you will use DC 1-10V signal dimmer, Please No.1 set “ON mode”

If you will turn off LED output when input signal voltage is low than 0.8V, Please No.2 set “OFF mode”.If you will turn on LED output when input signal voltage is low than 0.8V, Please No.2 set “ON mode”