finalprojectppt (1)
TRANSCRIPT
ONE M AN NE D AE R I A L CRAFT / POW E R E D HANG GL IDE R
I N T R O D U C T I O N
• It is a small light weight aircraft which consists of three wheel trike, the wing and a engine is mounted on rear side of the trike.
• The propellor is connected to the engine which gives some velocity to move the entire body.
• The wing is attached to the trike which is manually controlled by the pilot.
M AT E R I A L S U S E D
• Aluminium Alloy T6-6063
• Light weight Fabric similar to sail cloth
• Mild steel square hollow tubes for making trike
• Steel wire of dia. 4mm
• Nuts and Bolts
• Tools like drilling machine, hammer, spanners etc.
• Seat for trike
• 125cc Suzuki Engine, petrol tank.
• Battery, Spark Plug, wires, etc
S KE LE T O N OF T H E W INGS .
W INGS OVE R TH E S KE L E T ON
C O M PO N E N T S O F T H E A I RC RA FT
• Wooden Clock-Wise Propellor
• Engine to power the aircraft
• Trike
• Control Bar
• Wings
E N G I N E S PE C I F I C AT I O N S
• Engine Speed- 7000 rpm
• Engine Power- 7 kw @7000 rpm
• Engine Torque- 10 Nm @5000 rpm
• No of cylinder- single cylinder
• Stroke type- 4 stroke engine
• Fuel type- Petrol
W O R K I N G PR I N C I PL E
• The first and most impotent principle on which this unusual aircraft works is the weight to surface area ratio.
• Bernoulli’s principle is always in play .
• This aircraft dose not fly only by the force produced by the engine it only needs enough speed to keep the velocity constant and then it just glides .
S P E C I F I C AT I O NS OF T H E A I RC RA FT • Wing edge to edge span - 36.08 feet
• Edge pipe length- 21.64 feet
• Centre pipe length- 11.2 feet
• Kingpost length from nose- 4 feet
• Nose angle -112 degree
• Control bar angle- 45 degree
• Propellor Length- 3.10 feet
• Surface area of the wings- 48 sq.m
• Height from the wing from ground- 7 feet
• Engine transmission height from the ground- 4 feet
C O N C LUS I O N
• Standard One Manned Aerial Craft or powered hang glider is very costly. The minimum cost one can buy is around Rs.25 lacks.
• The project we have made is cost effective, and one can build their aircraft within Rs. 50 thousand.
• The main advantage over flying a hang glider is one does not require license to fly the aircraft.
T OTAL EX PEND I T U RE OF T H E PR O J EC T
• Rs. 46,952/- (Forty six thousand nine hundred fifty two)
RAW MAT E R IA LS
Nose Housing
Drilling Operation
SK E LE T O N O F T H E W I NGS
WI NG OF TH E HA NG GL IDE R
wings
propellor
cutting operations
Trike in making
Aluminium welding
Drilling Operation
sewing of wings
the wings
Assembling
Trike
wings skeleton
painting
T R I AL 1S T
T R IA L 2ND
T R I AL 3R D
THANK YOU