Models: SLSFE18FP | SLSFE24FP

FINGERPRINT-ENABLED

ELECTRONIC SAFEUSER MANUAL

2

! Please do not keep emergency keys in your safe!

FUNCTION

DIAGRAM

FEATURES

• Locks:usinghigh-qualityanti-drillinglockingbolts,high-theftproofperformance.• Initialization/Addkey:addfingerprintregistrationordeletefingerprintrecord• Unlockkey:openthesafe• Fingercollectorscreen:fingerprintregistration• Numberkeysonthepanel:representing1,2,3,4separately• Key"1":setusecode• Gildedbadge:removethecoverandopenemergencylock• Powersupply:4XAAbatteries

• Thissafeisahigh-techproduct,andplaysastrongroleinpsecurity.• Usefingerprintrecognitioninsteadofakeyordigitalcodeforgreaterconvenience• Maximumof20fingerprintscanberegistered• Constructedfromsolidmaterialstoresistattackfromhand&powertools• User-friendlyproduct,originaldesign,uniquestructure

3

!

!

!

!

NOTE: For security of your property, you will need to change the preset code.

PREPARATION

POWER SUPPLY

FINGERPRINT REGISTRATION

SET USER CODE

• Thesafeondeliverycomeswithnoregisteredfingerprints.• Thesafeisnotloadedwithbatteries,youmayinserttheemergencykeyintotheemergencykeyholetoopenthedoor.

• Uncoverthebatterycompartmentcoveratthebackofdoor.Andputin4XAAbatteries.Pleasepayattentiontothepolarityofthebatteries.Fornormaluse,thebatterieslastuptooneyear.

• Thepresetcodeofsafeondeliveryis"1234",theusermayopenthedoorwiththepresetcodewhenbatteriesareplacedandtestednormal.

• Pullthedooropen.• Pulloutthebatterycompartmentcover.• Replace4freshbatteriesbyliningthemupinamannerasindicatedbythe"+"and"-"signs.

NOTE: If the red light activates, it means the batteries are low. So you can plug the emergency battery boxes into the jack to power. While choosing batteries, it’s suggested to use high-powered, high quality alkaline batteries. Please do not use any inferior, counterfeit or carbon-zinc batteries.

NOTE: A maximum of 20 fingerprints can be registered.

NOTE: Factory preset code is 1234.

• PressInitialization/Addkey,andyou’llhearashort"Bleep,Bleep".• Putyourfingeratfingercollectorscreenwheretheredlightis.You’’llhear"Bleep,Bleep"fortwotimes.

• Afteraboutasecond,along"Bleep"followsashortone,whichmeansthatfingerprintregistrationsucceeded.(3 short "Bleep, Bleep, Bleep" means registration failed.)

• Accordingtothismethod,youcanregisterotherfingerprints.

Pressnumberkey"1"forabout5seconds,thegreenindicatorlightwillturnon.Inputthecurrent/originalcodeandpresstheunlockkeytoconfirm.Afterhearinga"Bleep",inputnewcode(4to8digits)andpresstheunlockkey.Inputthecodeagain,andpresstheunlockkey.Hearinga"Bleep"meanstheoperationwassuccessful.

4

SET USER CODE

EMERGENCY KEY

• Fingerprint unlock:Pressunlockkey,theredlightatfingercollectorscreenison.Don'tremoveanyfingerprintregisteredatfingercollectorscreenuntiltheredlightoff.Afterhearingalong"Bleep",thegreenlightshinning,motordrives.Pleaseturntheknobclockwise,thenunlocksucceed.

• Password unlock:Inputcode(4to8digits)andpressunlockkeytoconfirm.Afterhearingalong"Bleep",thegreenlightshinning,motordrives.Pleaseturntheknobclockwise,andunlocksucceed.

NOTE: In order to improve the success rate of finger identification, userscan refer to the following advice: Avoid using the finger collector screenin bright light. It’s suggested that each user registers 2-3 fingerprints. Women and children should try to register with thumb and middle finger. Try to press with even weight for an accurate print. Avoid pressing with too much or too little weight. If the air is very dry, try breatheing on fingers till a little wet.

NOTE: For your total security, please take care of the emergency key andkeep them in one secret place OUTSIDE of the safe.

!

!

Duringfirstuse,incaseofcircuitmalfunction,ifyouforgotyourcodes,oryourfingerprintisn’tbeingrecognized,youcouldalsousetheemergencykeytoopenthesafe.

• Useinside-hexagonalspannertoopenthegildedbadgeonthesafedoor,thenyouwillseetheemergencylock.

• Unlockwithemergencykey,andturntheemergencykeycounterclockwiseonthepanel.

• Turntheknobclockwiseandopenthesafedoor.

5

SYSTEM INITIALIZATION/DELETION

IMPORTANT NOTES

PresstheInitialization/Addkeyforaround5seconds,thegreenindicatorlightwillblinkabout12times.Letgoofthekeywhenitstopsblinking.Afterhearingalong"tick",allfin-gerprintsrecordsinthemodulewillbeeliminatedandreturntofactorysetting.

• Donotuseliquidorasprayertocleanthesafe.Useawetclothinstead.• Donotplacetheproductinaninsecureandelevatedplace,lestitmayfalloveranddamagetheproductorhurtpeople.Neverspillliquidoverthecontrolpanel,oritmaycauseelectricalshocktotheelectronicpartsinsideanddisabletheirproperfunctions.

• Nevertrytodismantletheproductbyyourself.UnguidedDismantlingandincorrectreassemblyoftheinsideofbackcovermaydamagetheelectricalcircuitandaffectsitsperformance.Wheremaintenanceisrequired,pleasecontactthelocalservicecenterorlocaldistributor.

For additional help, please consult the local distributor