Firmware Upgrade Instructions for DSL600EW IMPORTANT: After performing the following steps, all settings that are previously saved will be lost.

NOTE: This firmware upgrade instructions is only applicable if you are upgrading from

firmware version 43.xx.xx.

1. Logon to the router

2. Click ‘Advanced’ > click ‘Firmware Update’

3. Click 'Browse' > double-click ‘config.xml’

4. Click 'Update Gateway'

5. Once completed, click 'Browse' > double-click

‘ram_zimage.ar7xxx.nsp.squashfs.upgrade.bin’

6. Click 'Update Gateway'

7. Once completed, click 'Browse' > double-click ‘nsp.annexA.upgrade.img’

8. Click ‘Update Gateway’

9. When the message below appears, wait for about 2min before restarting the router:

10. After the router is switched on, wait for about 1min before performing a hardware reset:

- use a pin to press and hold the reset button for about 10sec

11. Clear your web browser cache

12. Logon to http://192.168.1.1 to configure the router