fleetwood door

8/4/2019 Fleetwood Door

http://slidepdf.com/reader/full/fleetwood-door 1/7

PATH: Body > Interior > Panels & Trim > Removal & Installation > Door Panel > Front Door

Front Door

Front door panel—1990–91 Deville and Fleetwood

Click to Enlarge

Front door panel—1992–98 Deville and Fleetwood

Click to Enlarge

of 7Chilton Repair Content - Classic Viewer Presentation

2/27/2011http://content.chiltonsonline.com/Repair/ClassicView.aspx?key=6kAUBD5BruOJf%2f3tg ...



Carefully pry up the power window switchplate and . . .

Click to Enlarge

. . . gently remove it from the door panel

Click to Enlarge





Remove the door pull strap retaining screw covers by gently prying them off

Click to Enlarge

Remove the door pull strap retaining screws

Click to Enlarge





Gently pull the inside door handle panel down and . . .

Click to Enlarge

. . . release the rod from the handle

Click to Enlarge





Carefully lift up the door panel to release the . . .

Click to Enlarge

. . . retaining pegs on the door panel

Click to Enlarge





Do not pull the panel too far away from the door, as some components still have wiring harness connected

Click to Enlarge

Detach any necessary wiring connectors and remove the door panel from the vehicle

Click to Enlarge

Disconnect the negative battery cable.1.

Insert a flat-bladed tool between the door panel and the rear edge of

the power window switch plate to disengage the retainer from the

panel.

2.

Slide the power window switch plate forward, then label and detach

the wiring connectors.

3.





Remove the power door lock switch plate retaining screw. Remove

the switch plate and detach the wiring connector.

4.

Remove the pull handle retaining screws.5.

Using a thin-bladed tool, carefully pry the courtesy lamp lenses off.

Remove the courtesy lamp bulb.

6.

Pinch the courtesy lamp retainers and pull out the lamp socket holder.

Detach the courtesy lamp wiring connector.

7.

Remove the door panel retaining screws.8.

Using tool J-2459B or equivalent, disengage the door panel fasteners

from the holes in the door. Detach any remaining wiring connectors

and remove the door panel.

9.

To install:

Position the door panel close to the door and attach the wiring

connectors.

10.

Align the door panel fasteners with the holes in the door. Push in on

the door panel to install it to the door.

11.

Install the door panel and pull handle retaining screws.12.

Install the courtesy lamps and switch plates.13.

Connect the negative battery cable.14.


fleetwood door

Documents