fxs series - sense.com.br · amplifiers are connected to the plc with a pnp ... reservamos-nos o...
TRANSCRIPT
FXS SERIESFIBER OPTIC AMPLIFIER
Configuration by jog switch
PNP / NPN universal output
Programmable output light-on or dark-on
Electrical connection by cable or M8 connector
Low power consumption (45 mA off)
Response time 2,5ms
Green, red or blue light source
Many options of fiber optic cable
FEATURES
EASY TO USE, EASY TO UNDERSTAND
Only two buttons are required for a complete amplifier setup. The L / D
button allows explore the option menu to configure the amplifier and
confirm the option desired.
The output circuit, has automatic recognition, allowing that the
amplifiers are connected to the PLC with a PNP or NPN input.
This recognition eliminates the adjustment by wire or jumper
and makes easy installation in the field eliminating incorrect
connection risk that could damage the amplifier.
FACTORY AUTOMATION
INDUSTRAIL SENSORS
TEACH FUNCTION- 1 POINT- 2 POINT- AUTOMATIC- MANUAL
TIMER FUNCTION- ON DELAY- OFF DELAY- SHOT
Fiber TypesDifuse Thru Beam
Rua Tuiutí, 1237 - Tatuapé - São Paulo - CEP: 03081-012 - Fone: 11 2145-0400 - [email protected] - www.sense.com.br
Reservamos-nos o direito de modificar as informações aqui contidas sem prévio aviso. 2000000XXX Rev. A - 06/2016
Adjust TypeJS - Adjust by jog switch
Light SourceR - Red LEDG - Green LEDB - Blue LED
OutputPN - PNP/NPN universal output
Electrical Connection__ - Cable with 2 meter - 3 waysV8 - M8 connector - 4 pins
ELECTRICAL CONNECTION
MECANICAL DIMENSIONS
FRONT PANEL
ModelFXS2 - Fier optic amplifier
FXS2 - JS - R - PN - V8
FIBER FITTING
HOW TO SPECIFY?
The fiber is easily connected to the amplifier, just lowerthe lock, insert the fiber to the end and lift the lock again.
When lifting the acrylic cover, we have access to the signaling LEDsand two buttons that allow to change the output mode to lightor dark and configure all functions of the amplifier.
L/D Green LED
Yellow LED: indica o status da saída Green LED: indica que o sensor esta em modo RUNRed LEDs: indica intensidade de luz ou programação do sensorJog Switch: Enter / funções do menuL/D: Seleciona modo Light ou Dark
Red LEDs
Yellow LEDJog Switch
L/D
FXS2-JS-R-PN
<< + Enter - >>
TimerShot
Manual
Out
T2Auto T
T1
Run
Fiber
By cable:
By connector:
BN - Positive
BK - Output
BU - Negative
1-Positive 3-Negative
2-NC 4-Output
73,47
14,76
37,1
73,47
14,76
37,1
14,15