g-scan update process - oem tools 2011 3 shut off power to scan tool, remove software card from the...
TRANSCRIPT
March 2011 Slide 1 of 13
GG--ScanScan Update ProcedureUpdate Procedure
CAS of New EnglandCAS of New EnglandFor Technical Assistance call 1For Technical Assistance call 1--877877--263263--4897 8:30am 4897 8:30am ––
4:30pm EST4:30pm EST
March 2011 2
Install GInstall G--Scan PC Utility softwareScan PC Utility software
After software is installed you should see the After software is installed you should see the below user interface screen.below user interface screen.
Click on the [Software Update] ButtonClick on the [Software Update] Button
March 2011 3
Shut off power to scan tool, remove software card from the bottoShut off power to scan tool, remove software card from the bottom and m and install in the card reader. Insert into PCinstall in the card reader. Insert into PC’’s USB port. Wait for PC to s USB port. Wait for PC to
recognize and install USB Port hardware. When done Click [Next] recognize and install USB Port hardware. When done Click [Next] on the on the PC screen.PC screen.
March 2011 4
Click [OK] at the prompt.Click [OK] at the prompt.
March 2011 5
Click [OK] at the next prompt.Click [OK] at the next prompt.
March 2011 6
Check that the settings match as Check that the settings match as pictured and then click [Start]pictured and then click [Start]
March 2011 7
Click [OK] at the next prompt.Click [OK] at the next prompt.
March 2011 8
Click [OK].Click [OK].
March 2011 9
Click [Close]. Update then starts automatically.Click [Close]. Update then starts automatically.
March 2011 10
Software update progress bar.Software update progress bar.
Wait until Blue Bar completes the process. This may take as longWait until Blue Bar completes the process. This may take as long
10 10 minutes. Do not interrupt, do not disconnect USB. It is suggesteminutes. Do not interrupt, do not disconnect USB. It is suggested you do d you do
not use PC for any other operations during this download processnot use PC for any other operations during this download process!!
March 2011 11
Click [Done] when finished, then close the Update Click [Done] when finished, then close the Update Program on your PC. Program on your PC. Read below WarningRead below Warning……
WARNINGWARNING: DO NOT disconnect SD card from USB interface if : DO NOT disconnect SD card from USB interface if RED RED light is on. You must 1light is on. You must 1stst
click on the click on the ‘‘Safely Remove HardwareSafely Remove Hardware’’
icon on icon on your PC Taskbar that allows you to your PC Taskbar that allows you to ‘‘ejecteject’’
the device. the device. Once Red light goes off it is safe to remove the SD Card.Once Red light goes off it is safe to remove the SD Card.
March 2011 12
Insert SD Card into the GInsert SD Card into the G--Scan. Power it up Scan. Power it up and the tool will auto update.and the tool will auto update.
CAS of New EnglandCAS of New EnglandFor Technical Assistance call 1For Technical Assistance call 1--877877--263263--4897 8:30am 4897 8:30am ––
4:30pm EST4:30pm EST
March 2011 Slide 13 of 13
GG--ScanScan
Update ProcedureUpdate Procedure
! End of Process !! End of Process !
CAS of New EnglandCAS of New EnglandFor Technical Assistance call 1For Technical Assistance call 1--877877--263263--4897 8:30am 4897 8:30am ––
4:30pm EST4:30pm EST