gas boosters and air blowers

Model U2000A Gas Boosters and Air Blowers These centrifugal gas boosters and air blowers are of robust construction and designed to run continuously under full load conditions handling a wide variety of gases or air. The shaft is sealed to isolate the bearings. Machines have a cast iron bearing housing, with aluminium volute casing and stainless steel anti-surge impeller. Boosters can be supplied bareshaft, as a basic unit with baseplate and motor, or as a package with mechanical and electrical protection equipment ﬁtted and wired, to comply with IGEM/UP/2 and/or customers bespoke requirements. All options are available as multiple sets for standby or assist operation, and packaged with approved controls. Compliant to : IGEM / UP / 2 ATEX DIRECTIVE : 2014 / 34 / EU MACHINERY DIRECTIVE : 2006 / 42 / EC BSEN 8487 : 2007 Ancillary Equipment: • Pressure switches • Isolating valves • Flexible connectors • Non-return valves • Acoustic/weatherproof enclosures • Motors and ancillaries for zoned areas • Control panel, Inverter control • Filter silencer for blowers/exhausters Air Blowers: Aeration Burners Gas Boosters: Burners Gas Engines Waste Gas Burners Siloxane & H2S Filters

Upload: others

Post on 23-May-2022

2 views

Category:

Documents

0 download

Report

Download

Embed Size (px):

TRANSCRIPT

Model U2000A

Gas Boosters and Air BlowersThese centrifugal gas boosters and air blowers are of robust construction and designed to run continuously under full load conditions handling a wide variety of gases or air. The shaft is sealed to isolate the bearings.

Machines have a cast iron bearing housing, with aluminium volute casing and stainless steel anti-surge impeller.

Boosters can be supplied bareshaft, as a basic unit with baseplate and motor, or as a package with mechanical and electrical protection equipment fitted and wired, to comply with IGEM/UP/2 and/or customers bespoke requirements.

All options are available as multiple sets for standby or assist operation, and packaged with approved controls. Compliant to : IGEM / UP / 2 ATEX DIRECTIVE : 2014 / 34 / EU MACHINERY DIRECTIVE : 2006 / 42 / EC

BSEN 8487 : 2007

Ancillary Equipment:• Pressure switches • Isolating valves • Flexible connectors• Non-return valves • Acoustic/weatherproof enclosures• Motors and ancillaries for zoned areas • Control panel, Inverter control• Filter silencer for blowers/exhausters

Air Blowers:Aeration Burners

Gas Boosters:BurnersGas EnginesWaste Gas BurnersSiloxane & H2S Filters

PRES

SURE

RIS

E - M

BAR

Whilst the details contained in this leaflet are representative of the machines, the actual products may differ from the illustrations due to improvements in design or change in specification. Certified drawings and performance curves will be supplied on request.

The Utile Engineering Co. Ltd. Irthlingborough, Northamptonshire. NN9 5UG. EnglandTel: +44 (0)1933 650216 Fax: +44 (0)1933 652738 E-mail: [email protected] www.utileengineering.com

MODEL U2000 (NAT GAS SG=0.6) MODEL U2000 (BIO GAS SG=0.8)

Dimensions & Performances

Materials of Construction

Outlet OrientationsPR

ESSU

RE R

ISE

- MBA

0 400 800 1200 1600 2000 2400

KILOWATTS

L0 Discharge

R0 Discharge