gpm2000 installing guide-english
TRANSCRIPT
GPM2000Installation and Setting
Professor Technology Co., Ltd.@2008
1
SYSTEM Connection
Professor Technology Co., Ltd.@2008
2
Getting ready to start setting1:take out the GPM2000, connect the IO cable , connect GPRS
antenna and GPS antenna. Please find the power to connect to IO
cable to provide power source for GPM2000 by connecting RED and
Black cable like in this picture
2.take down bottom cover of GPM2000. insert your SIM Card.
3. turn on the power source for GPM2000 then you can see the LED
lighted at “PWR” in red color.
4. power off.
Professor Technology Co., Ltd.@2008
3
Installation of SIM card setting and
GPM2000 setting1. Use connection cable. One micro fit side connect to GPM2000 and RS232 DB9
connect to your PC’s COM port.
2. open file SETUP SOFTWARE P2PServer .exe , like the picture shown below…
Normally JUST ONLY SETUP APN .
Sometime need setup ID
Other are factory Default Setting.
Professor Technology Co., Ltd.@2008
4
POWER ON GPM2000
Professor Technology Co., Ltd.@2008
5
Setup COM PORT
Professor Technology Co., Ltd.@2008
6
SETUP APN
Professor Technology Co., Ltd.@2008
7
SETUP Frequency Band
Professor Technology Co., Ltd.@2008
8
SETUP ID
Professor Technology Co., Ltd.@2008
9
SETUP IP PORT
Professor Technology Co., Ltd.@2008
10
SETUP SMS NO
Professor Technology Co., Ltd.@2008
11
SETUP DIAL NO
Professor Technology Co., Ltd.@2008
12
SETUP Monitor NO
Professor Technology Co., Ltd.@2008
13
SETUP Fixtime Report
Professor Technology Co., Ltd.@2008
14
Setup intelligent Report
Professor Technology Co., Ltd.@2008
15
SETUP Fix Distance Report
Professor Technology Co., Ltd.@2008
16
SETUP MAX Speed Limited
Professor Technology Co., Ltd.@2008
17
3. it will show firmware’s version and please check out the LED on the GPM2000
PWR( Red) fix lighted means power is on.
GPS Green slow flashing lighted means GPS is getting the signal
Fix lighted means GPS is ready.
GSM Yellow slow flashing lighted means GPRS is connecting to Server
Fix lighted means GRPS has connected to Server.
4. After GPS and GPS had both ready connected
Please follow this command for reference.
If customer use for testing in professor’s control center sever, please follow the setting
in red line in column
SETP Command function Notes
1 &&Z10,?,?,?,? GPRS network info.
?:internet
?user name(optional)
?:password(optional)
?:enable/disable(0:disable 1:enable)
2 &&Z11,?,? GSM Frequency
?:frequency( 3>900&1800MHz)
( 4>800&1900MHz)
?: enable/disable(0:disable 1:enable)
3 &&Z12,?,?,? ID setting
?:company’s name(exp:professor)
?:Car ID(exp:PJ00201)
?: enable/disable(0:disable 1:enable)
4 &&Z39,?,?,?,? IP address
?: established(please set:1)
?:Server IP address (exp:60.251.213.116)
?:Port(exp:7000)
?: established(Please set 1)
5 &&Z31,?,? Fixed time report?:time length (unit: seconds)
?: enable/disable(0:disable 1:enable)
Professor Technology Co., Ltd.@2008
18
6 &&Z32,?,?,? Intelligent report
?:time length when ACC ON (unit: seconds)
?: time length when ACC OFF (unit: seconds)
?: enable/disable(0:disable 1:enable)
7 &&Z36,?,? Fixed distance report?: distance length (unit:Meter)
?: enable/disable(0:disable 1:enable)
8 &&Z05,?,******Phone number setting (country codec +Area codec +phone number)
Please check protocol document V8.6 for more details.
9 &&Z06,?,886***Phone number
(monitoring) setting
(country codec +Area codec +phone number) Please
check protocol document V8.6 for more details.
Professor Technology Co., Ltd.@2008
19
5. Finish setting
Installing to car SETP by STEP1. Please check all the accessories like in this picture.
Professor Technology Co., Ltd.@2008
20
Professor Technology Co., Ltd.@2008
21
2. Find the power source in your car.
Depends on different car,Usually looking for fuse box. 。 Fuse Box (use accessories: IO power wiring Cable)to connect the power
source for GPM2000.
Professor Technology Co., Ltd.@2008
22
There is two ways to connect the power source
Red cable (+)from IO Cable goes Car battery, Yellow Cable (+) goes to
ACC
Both Red cable (+) and Yellow Cable (+) from IO Cable, goes to ACC
Find the suitable place to fit the GPM2000 unit like glove compartment
Or under the steering wheel to hide the GOM2000 unit.
Professor Technology Co., Ltd.@2008
23
There is two ways to fasten GPM2000 please make sure the GPM2000 will not fall
down by the shakiness from your car.
a: use the cable tie
b: use the 3M dual-lock tape.
3. Installing other Accessories
GPS Antenna
GPS antenna can’t work under any cover upon it, please fasten it with a
antenna holder ( Accessories pack) on the windshield in the middle, GPS
antenna top must be facing up to the sky, do not facing down to dashboard!
Also adjust the angle 12~15 of the antenna holder to prevent the antenna
face up to the top of the car.!
GSM Antenna
GSM is much easier than GPS antenna. You can put where ever you want
to. Better not stacking with GPS antenna.
Speaker and Microphone
As you can see in the picture below, Speaker should be placed as possible as
near the Driver side of dashboard to get the better sounds effect, but not
blocking driver’s view! Microphone should be placed on the top higher
away from speaker, remember the Microphone must point to the driver’s
side to get the better sounds effect. Professor Technology Co., Ltd.@2008
24
SOS button Cable(optional)You can choose where ever to place this SOS cable. Where for driver can
easily reach and activate SOS signal.
4. Activate the internal battery, please use the Jumper in Accessories pack and
follow the picture below to activate the battery. After you placed the jumper on
GPM2000, you will see the power LED (Red ) is light on.
5. Finishing the installing
Checking the GPM2000’s functions
1. set a new customer account in fleet management system software,(if you
didn’t have your own software of fleet management, please contact us for
help by using PROFESSOR fleet management system DEMO version)Professor Technology Co., Ltd.@2008
25
2. checking the fleet management system has your car show on the map, if it does
show on the map, that means the GPS signal and GSM signal of GPM2000 you
have installed in your car is working.
3. use your cell-phone to dial the predefined phone number you had installed in
GPM2000, then you will hear the speaker in the car has ringing tone and after
few ringing tone, the GPM2000 will pick up the phone call automatically then
you can try to speak through Microphone in car. If not, please check the number
you have set in GPM2000 is the right one, and check the speaker and
Microphone are well connected to GPM2000.
4. push the SUS button, (if you had installed the SOS cable to GPM2000) then
check your cell-phone have received the SOS SMS from GPM2000。If not,
please check you have set your phone number into GPM2000 to send out the
SMS message.
5. finish, you can now testing the GPM2000 with your car and running..
Tracking form WEBProfessor Technology Co., Ltd.@2008
26
Goto WEB http://www.professor.com.tw
Professor Technology Co., Ltd.@2008
27
Professor Technology Co., Ltd.@2008
28
Professor Technology Co., Ltd.@2008
29
Professor Technology Co., Ltd.@2008
30
Professor Technology Co., Ltd.@2008
31
Track Playback
Professor Technology Co., Ltd.@2008
32