how to change computer chip inside water bottle
TRANSCRIPT
How to change computer chip inside water bottle return cage
• Unplug the unit to ensure no power is connected.
• No lights on the front of the drawer should be illuminated
• Insert key and rotate clockwise to unlock drawer.
• Pull drawer ¾’s of the way out of the unit.
• Remove the Blue/Black plastic shield that is between the ticket tray and the circuit board. It has a small amount of adhesive to keep it in place. The shield should break free with a small upward tug.
• If the shield will not break free easily, remove tickets from tray; place the enclosed screw driver between the ticket tray and the plastic shield and twist to break the seal.
• To remove chip use the tool included. Metal prongs are what grab the chip.
• Insert metal ends into the slots at the top right and lower left of the chip.
• Squeeze the grips of the tool together until you feel the chip begin to dislodge
• While maintaining pressure on the handles of tool remove the chip completely.
• The tool is not needed to install the new chip
• Insert new chip with the writing facing up into the circuit board in the same location as the old chip was just removed from.
• Apply pressure to the center of chip to ensure that it is seated properly.
• Re-insert plastic shield to its original position
• Close drawer and turn key counterclockwise to lock unit.
• Plug unit in
• Yellow light should be illuminated on the front of the drawer.
• If tickets needed to be removed, unlock and open drawer to re-load tickets. You will first need to press the auto feed button on the back to remove the left over ticket.
• Place the tickets back into the tray and insert ticket into feeder.
• Press the auto feed button to set the ticket.
• Close drawer and remove key.