how to install - vitasmart
TRANSCRIPT
HOW TO INSTALLUNDER-SINK CARTRIDGESReplacements Procedure
KNOW YOURPURIFIER
vitasmart.com.au
#8 Purifier Outlet Nozzle
#7 Purifier Inlet Nozzle
#5 Purifier Housing
#9 Wrench
This is a consumer-friendly procedure which can be followed to replace universal water filter cartridges in any single-stage, 2-stage, or multiple-stage under-sink Purifiers.
FIGURE A
Turn off the Under-Sink Cold Water Supply Tap (#1) and relieve pressure through the Sink Tap (#4)
TURN OFF UNDER-SINK COLD WATER1
#4 Sink Tap
#8 Purifier Outlet Nozzle
#7 Purifier Inlet Nozzle
#1 Cold-Water Supply Tap
#5 Purifier Housing
HOT COLD
FIGURE B
#2 Outlet Hose
Inlet Hose#6
Hot Water Hose#3
Unscrew Housing (#5) with suitable wrench (#9). Refer to Figure C2
Close
Open
FIGURE C
#5 Purifier Housing
#9 Wrench
FIGURE D
Filter Housing
O’ring a. Drain the waterb. Remove old Cartridgec. Ensure the inside of the Housing is cleand. Ensure the O-ring within the Housing remains in position (Refer to Figure D)
3
Place the new Cartridge(s) in the Purifier Housing (#5) and screw the Housing back on using wrench (Refer to Figure C)
4
Close
Open
FIGURE C
#5 Purifier Housing
#9 Wrench
Note:For 2-Stage and multiple-stage Purifiers, please ensure each Cartridge is installed in the correct position (refer to Figure E).
If you have any questions or technical enquiries, please email us at [email protected]
4Inlet Outlet
Position 1
Position 2
FIGURE E
Turn on the Under-Sink Cold Water Supply Tap (#1) to fill the Purifier and ensure no leaks5
#4 Sink Tap
#8 Purifier Outlet Nozzle
#7 Purifier Inlet Nozzle
#1 Cold-Water Supply Tap
#5 Purifier Housing
HOT COLD
FIGURE B
#2 Outlet Hose
Inlet Hose#6
Hot Water Hose#3
6Run the system by opening the Sink Tap (#4);keep the tap open to drain for a minimum of 10 min.
Notes 1. You may initially observe a whitish water colour; this is a normal phenomenon consisting of air bubbles, and will clear after draining 2. If system is left unused for a period of longer than 3 days, please flush for 5 min. prior to usage
#4 Sink Tap
#8 Purifier Outlet Nozzle
#7 Purifier Inlet Nozzle
#1 Cold-Water Supply Tap
#5 Purifier Housing
HOT COLD
FIGURE B
#2 Outlet Hose
Inlet Hose#6
Hot Water Hose#3
63. Recommended water supply pressure: 2 – 6 bar & max. temperature 38° C
4. Filter cartridges’ lifespan vary according to water quality and frequency of use. Change cartridges on a regular basis (3-6 months) to prevent deterioration of water quality.
Please visit www.vitasmart.com.au to register your system and optimise your change frequency through our free tool. The VitaSmart algorithm helps you save on additional costs by avoiding unnecessary changes.
#4 Sink Tap
#8 Purifier Outlet Nozzle
#7 Purifier Inlet Nozzle
#1 Cold-Water Supply Tap
#5 Purifier Housing
HOT COLD
FIGURE B
#2 Outlet Hose
Inlet Hose#6
Hot Water Hose#3