hydrosafe vg32

8/12/2019 HydroSafe vg32

http://slidepdf.com/reader/full/hydrosafe-vg32 1/3

Click onany of thefollowing

to findout more

about our

ISOGrade

32,46,68products

and

WaterGlycol

200.

Product Data

Hydro Safe ISO VG 32

Non-Toxic - Biodegradable - Environmentally Friendly

Antiwear - Hydraulic OilHydro Safe ISO VG 32 is a vegetable based hydraulic fluid formulated to meetthe demand for biodegradable hydraulic oils. It is designed to minimizeenvironmental impact and have low environmental persistance. Hydro Safe IS

VG 32 offers excellent antiwear performance in a wide array of hydrauliccomponents, and can be used as a superior replacement for conventional

petroleum oil. It exhibits good thermal and oxidative properties when compareto other vegetable-derived products. Formulated from canola oil, and containibiodegradable, non-toxic chemical additives. Its high vicosity index (VI) allows

outdoor operations in winter and summer without the need for fluid changes oequipment modifications.

Viscosity Index ASTM D-567, ASA Z11.45 is an empirical number indicating trate of change in viscosity of an oil within a given temperature range. A lowviscosity index signifies a relatively large change in viscosity with temperaturechange, while a high viscosity index shows a relatively small change in vicosity

with temperature change. Viscosity Index cannot be used to measure any otherquality of an oil.

The fluid is totally biodegradable, and exceeds the government criteria of bein"readily biodegradable." Readily biodegradable is defined as an attribute ofproducts that have a natural ability to biodgrade quickly and completely. Oncthe fluid is leaked into the ground, it has the ability of substance to be digested

consumed by naturally occurring microorganisms present in water, air, and sosystems. Complete biodegradability is the conversion of a substance to carbondioxide and water.

Typical Physical Properties

Appearance Clear Light Amber

Hydro Safe -- ISO VG 32

11/3http://www.hydrosafe.com/vg32.html



ExecutiveSummary

Fire

ResistiveTechnical

Article

Fluid Viscosity, SUS@210 °F 48.8 Viscosity, SUS@100 °F 150 Viscosity Index 202 Total Acid Number - mg KOH/gm 2.35 ASTM Flash Point, C.O.C., °F 485 ASTM Fire Point, C.O.C., °F 575

ASTM Pour Point, °F 10.0 ASTM Freeze Point, °F 5.0 Specific Gravity 0.915 Dielectric Strength Test - ASTM D877 38.9 KVAC Corrosion Test - ASTM D665A Pass Density (Pounds Per Gallon) 7.63 lb/gal Oxidation Test R.B.O.T. A.S.T.M. D2272 165 min.

The oil has been thoroughly tested, and meets or exceeds the industry standard

Vickers V-104-C extended vane test, as well as other mechanical, engineering,lubrication and wear tests, to ensure compatability and extended wear proper

The following Hydro Safe Oil values are what one might expect from currentlyavailable high performance mineral oils. Results ASTM D2882 Modified PumpTest.

Pump Vickers V-104-C Pressure, PSI 1500 Temperature, °F 150 Theoretical Output, GPM 7.5 Filter, Micron 10 Nominal Capacity, Gal. 5

Results

Duration, hrs. 504 Ring Loss, mg. 3.9 Vane Loss, mg. 1.0 Total Loss, mg. 4.9 Wear Rate mg/hr 0.009

ASTM D2691 Hydrolytic Stability Test - This test measures the fluid's ability t

resist breakdown in the presence of heat and water. The amount of base needeneutralize water layer in the test at its conclusion was 7.0 mg. This is anexceptionally low value and indicates that the product is very stable even unde

the most adverse conditions and will not be aggressive toward metal andcomponents in the hydraulic system.

Storage/Handling/Disposability

No health or safety hazards exist when Hydro Safe ISO VG32 is stored, used adisposed of in accordance with instructions given on the Material Safety DataSheet for this product.

Warranty





The information given here is considered to be correct and is offered for your

consideration, investigation and verification. No warranties are expressed orimplied since the use of Hydro Safe products is beyond our control. Statementsconcerning the use of Hydro Safe products are not to be construed asrecommending the infringement of any patent.

Export Statement

This commodity and its technology are subject to the export control laws andregulations of the United States Government. Buyer agrees that it shall not ma

any disposition, by way of export, diversion, trans shipment, re-export orotherwise, except as expressly permitted under United States law.

Shipping Point: Chicago ISO-9002 Certification

Click for the MSDS



hydrosafe vg32

Documents