Fab academy 2012

CLASS 10: INPUT DEVICES (mar 28) STUDENT: WALTER HECTOR GONZALES ARNAO

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Fab academy summary

this week we built a card and connect a sensor (Phototransistors) to a microcontroller (atinity 45). after programming the microcontroller visualize bars of blue and red horizontal, varying with the incidence of light.

CLASS 10: INPUT DEVICES (mar 28) UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Fab academy

FIRST STEP. WILL WORK WITH THE PAST YEAR CARD CLASS 10: INPUT DEVICES (mar 28)

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Fab academy 2012

STEP TWO. ATTEMPT TO SET IN AVR STUDIO, THAT LOW INTERNET To run CLASS 10: INPUT DEVICES (mar 28)

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Fab academy 2012 STEP THREE. RESPONDIA NOT BECAUSE THE ERROR WAS ON THE

CARD THAT TRACKS missing that will link the PUSH CLASS 10: INPUT DEVICES (mar 28)

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Fab academy 2012 STEP FIVE. PLACED IN THE BRIDGE ON THE TRACK IN THE

DIRECTION OF THE BUTTON, AND OTHER TRAJETA COURT AGAIN TO LIST THE CARD TODO.LA and lit the AVR PROVE THAT MEANS THAT IS READY CLASS 10: INPUT DEVICES (mar 28)

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Fab academy 2012

PASO 6. CONECTE LA TARJETA EN EL PROGRMADOR ARDUINO CLASS 10: INPUT DEVICES (mar 28)

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Fab academy 2012

STEP SEVEN. CODE IS INTRODUCED AND ACTIVE CLASS 10: INPUT DEVICES (mar 28)

UNIVERSIDAD NACIONAL DE INGENIERÍA FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Fab academy 2012

STEP 8.SE turned on the LET CLASS 10: Embedded Programming UNIVERSIDAD NACIONAL DE INGENIERÍA

FACULTAD DE ARQUITECTURA, URBANISMO Y ARTES

Conclusions. conclusions 1. The construction of the card with the microcontroller and the light sensor is simple, however because we weld the parts. All information take it from the tutorials 2. The second part is complicated by the programming of the microcontroller, which was displayed not bar recognition of the sensor in your computer monitor. 3. I asked for help to our colleagues, for the programming, the support that but I was Henrry.