Installation guide for 2010 2011 Mazda 3

gps navigation with 3G WifiHave you installed a dvd player for your 2010 2011 Mazda 3?

Maybe you will say that all things for installation can be solved by

professional technicians.However,its very possible for you to

achieve it yourself with installation guide for 2010 2011 Mazda 3

gps navigation with 3G Wifi.But to avoid damage or

accident,please do not disassemble the unit privately.

Before removal,you can start the radio to check whether the

dashboard function display and button operation is normal;the

surface of car inside and outside whether have any unnormal

phenomenon.If everything is ok,then you can begin your action

about car radio.

To be honest,modern dvd player can bring you too much

entertainments and convenience.So what specific process is? Dont

worry,this article will tell you how to upgrade the head unit of your

car.

1.Pry and remove air vent with a plastic scraper or panel removal

tool to avoid damaging the plastic

2.Put air vent in front place and first remove two screws holding

the radio in place

3.Next slide one finger down each side behind the panel,pull the

radio forward and up to remove it

4.Disconnect the grey antenna connector(a screw will help unlock

it)

5.Disconnect the stock AUX input connector

6.Flip the stock radio over so you can see the locking tab on the

main connector,then disconnect the main connector

7.Here is the empty radio bay,ready for your new unit

8.Connect the eonon wiring harness,one by one:aux input

cable,canbus adapter,antenna adapter,main connector

9.Install the GPS antenna:this location just under the dash behind

vents gets excellent reception and does not require any visible

wiring

10.Remove the DVD lock-down screws

11.USB and Ipod/Ipad cables:one location for these is in the glove

compartment,one 3/4 hole will allow all three cables to pass;use a

3/4 wood-boring bit,and drill carefully so the drill does not go

through any farther than necessary

12.Insert the USB cables from the radio side,insert the Ipod cable

from the glove compartment

And final connections and fit

13.Connect the remaining cables:

GPS and WIFI antenna(gold)

IPod/iPad cable(black)

Aux L/R(red/white)

Main Harness(black)

14.Tidy the cables up and slide the radio into position

15.Place the WIFI antenna to the left of the GPS antenna,in front of

the instrument cluster.Route the cables so they come down

between the two ventilation openings as shown.Extra cable may be

cliled,tied,and stowed deeper into the cavity behind the vents

16.Re-connect the car battery and power up the radio to make sure

it works.With the radio on,test the steering wheel buttons as well

17.Install the two screws that secure the radio in the dash

18.Finally,check that all of the wires are still in place,and re-install

the ventilation panel

19.New unit after upgrade, stereo autoradio with gps bluetooth 3G

Wifi of 2010 2011 Mazda 3

This is all operations for Mazda 3 gps sat navi system

installation.And here are some warm prompt:

1.Do not wash the unit with strong chemicals,cleaning agents,or

strong detergent

2.If you will wipe the screen ,youd better use a clean soft fabric

to,not ordinary fabric

3.Please dont use other sharp objects but the touch screen pen to

operation unit, ,or it will damage to the screen

For more information about car dvd,you can visit the following

website: http://www.seicane.com/8-inch-in-car-gps-navigation-stereo-

replacement-for-2010-2011-mazda-3-with-3d-map-cd-dvd-player-

bluetooth-music-mp3-tv-tuner-3g-wifi-aux-1080p-dvr-pop-hd-video-c034.