Installation InstructionsThank you for purchasing the WeatherTech® No-Drill MudFlap. Please read this installation guide to thoroughly familiarize yourself with the steps to install the MudFlap on your vehicle. When properly installed, the WeatherTech® No-Drill MudFlap will provide you with years of protection.

- 7/16" Box End Wrench- Small Phillips Screwdriver- Stubby Phillips Screwdriver

Parts Kit (R)(2) % x 20 x 1" Phillips Head Bolts(2) % x 20 Locknuts(2) %" Washers(1) 5/32" Hex Key

WARNINGThe MudFlap is designed to fit vehicles with standard size wheels and tires. Installation of MudFlaps on vehicles with aftermarket wheels or oversize tires may interfere with the MudFlap, will void the warranty and may damage the MudFlap or the vehicle.

1 Start by thoroughly washing your vehicle. Take care to remove all dirt, debris, and stains from each fender in the areas corresponding to where the MudFlaps will be installed.

2 Park the vehicle on level ground with the wheels turned fully to the left. Begin with the driver’s side MudFlap installation.

3 Locate the plastice rivet holding the fender flare. Using the small phillips screwdriver, carefully unscrew the center portion of the rivet. 4 When the rivet head is exposed, it can be pulled out. Now remove the other piece of the rivet. You will now have an exposed mounting hole.

MF101

View Easy Installation Video WeatherTech.com/install

Questions? Call customer service at 630 769 1500 Monday - Friday: 9 a.m. to 5 p.m. Central Time

WeatherTech.com/install

5 Identify the driver’s side MudFlap by locating the “LH” mark located centrally in the recessed cavity on the tire side of the MudFlap. Ensure that the QuickTurn™ fastener is in the fully unlocked position using the hex key provided.

6 Locate the plastic tap on the mudflap indicated. This tab fits behind the plastic fender flare as shown.

7 Rotate the flap up into place lining up the hole in the MudFlap with the hole in the fender. Using the bolt, washer and nut, attach the MudFlap loosely. 8 While insuring that the MudFlap conforms tightly to the fender flare, use the hex key and tighten the QuickTurn™ fastener. Make sure it goes fully to the locked position. QuickTurn™ fastener should rotate easily to the locked position an then require more force to tighten.

9 After tightening the QuickTurn™ fastener, fully tighten the nut bolt. Repeat these steps on the passenger side of the vehicle.

Congratulations!

Your new WeatherTech® No-Drill MudFlaps have been installed!

Your WeatherTech® No-Drill MudFlap carries a Lifetime Warranty against defects in materials and workmanship when installed correctly.

View Easy Installation Video WeatherTech.com/install

Questions? Call customer service at 630 769 1500 Monday - Friday: 9 a.m. to 5 p.m. Central TimeMF101

© 2012 by MacNeil IP LLC

WeatherTech.com/install

1

2

3

4

5

6

7

8

9

Congratulations!