instructions for use nazalus implantsnazalus implants instructions for use in a severely resorbed...
TRANSCRIPT
www.southernimplants.comInternational distribution contact details are on our website
Images are for illustration purposes only and do not necessarily accurately represent the product.
Page 1 of 2CAT-8000-02 (C833)
Nazalus Implants
Instructions for use
In a severely resorbed maxilla Zygomatic Implants can be used to make use of the zygomatic bone. Similarly, Nazalus Implants enable use of the
maxillary bone surrounding the nose.
The implant site begins in the alveolar bone at the pre-molar and ends in the bone separating the maxillary sinus and nasal cavity.
The specialized implants need to be extra-long to span across the sinus and they need to be angulated at 24°. Therefore the prosthetic axis of the
implant is designed at 24° to the implant body (the Co-Axis™ concept) and the implant is available up to a length of 24mm. Full product details and
drilling protocol follow overleaf.
Placement position is shown in the figures below. It is important to note that bone grafting is recommended when the alveolar bone thickness is less
than 3mm.
> 3mm alveolar bone = no bone graft
Images courtesy of Dr Pietro Ferraris and Dr Giovanni Nicoli
1-3mm alveolar bone = bone graft
www.southernimplants.comInternational distribution contact details are on our website
Images are for illustration purposes only and do not necessarily accurately represent the product.
Page 2 of 2CAT-8000-02 (C833)
‘IBNT’ Ø3.43 Restorative Platform
24°
Leng
th (
Sur
face
Enh
ance
d)
Ø4.07
IBR24d
Length Implant Final Drill
20 IBR24d-20 D-33TP-20
22 IBR24d-22 D-33TP-22
24 IBR24d-24 D-33TP-24
2.54 Hex
Pre-mounted withFixture Mount
'IBT' Ø4 Implant Body
>3mm
(1) D-20T-M24 (2) I-DG-24 (3) D-33TP-20 (4) IBR24d-20
(5) IBR24d-20 with bone graft
24mm
22 mm
20mm
18mm
0. Initiate the site preparation with a round burr or equivalent drill 1. If the alveolar has more than 3mm of good bone, use the Ø2x24mm pilot drill to drill through the alveolar, into and across the sinus, engaging the lateral nasal wall. 2. The 24mm depth gauge can be used to palpate the hole depth for implant selection 3. Drill to final depth with the D-33TP final drill using low speed (350rpm)4. Place the implant in accordance with standard Co-Axis™ implant placement procedures, ensuring the prosthetic axis of the implant is aligned correctly 5. NB: If the alveolar bone is less than 3mm thick or of poor quality then bone grafting must be applied. Open a window in the lateral sinus wall. Gently reflect the Schneiderian membrane and insert bone graft into the sinus.
Site Preparation Sequence
Nazalus Implants
Instructions for use
(Illustration are for 20mm implant)
2mm