introduction of gsm
DESCRIPTION
just introduction of what is GSM and what is the basic feature of my point and basic command i just start to learn not expert :)TRANSCRIPT
GSM
AHMED NASSER SALEH
WHAT IS GSM
•Component provide ::
•.. Short Message Service
•Audio
•GPRS
FEATURE OF GSM
• Fully compatible with Arduino / Freaduino and Mega.
• Free serial port connecting, you can select Hardware Serial port(D0/D1) control or Software Serial port(D2/D3) control it.
• Control via AT commands (GSM 07.07 ,07.05 and EFCOM enhanced AT Commands)
• Supply voltage range : 3.1 … 4.8V
• SIM application toolkit
• Operation temperature: -40°C to +85 °C
• Low power consumption: 1.5mA(sleep mode)
SOFTWARE NEED
• Arduino IDE 1.0.x
• Serial Tool-sscom32
INSTALL GSM HARDWARE
• Hardware Operation
• - Install the SIM card into your GPRS Shield.
• - Take an Arduino board and install the GPRS Shield over it.
• - Connect the antenna to the GPRS Shield.
• - Connect the Arduino to your computer using a USB cable.
• - Plug the power adapter to Arduino.
• - Press and hold the power button a short while(Over 3 seconds) on the GPRS Shield
to turn it on. Wait half a minute for the GPRS Shield to connect to the network (NET
LED will start blinking every 3 seconds or so). If it continues blinking every 800mS,
which means EFCom can’t connect to the Internet, please re-
plug the SIM card and re-plug it., or try another card .
AT COMMAND
Command Response Why
AT OK
AT+CMGF=1 OK 1 text mode 0 binary mode
AT+CMGS=”+86158×× ×××× ”
OK (Start Typign Message and press CTRL+Z)
“ATD158 ××××××;” OK Calling Number
For more command :D seehttp://elecfreaks.com/store/download/datasheet/rf/SIM900/SIM900_AT%20Command%20Manual_V1.03.pdf
PICTURE
THANKS
Every thing I will learn will write here in
GSM
Links that help me :: http://www.elecfreaks.com/4446.html
http://www.elecfreaks.com/wiki/index.php?title=EFCom_GPRS/GSM_Shield