isa bus (industry standard architecture). tipe-tipe bus bus isa bus isa (industry standard...

ISA BUS (Industry Standard Architecture)

TIPE-TIPE BUS

BUS ISA

Bus ISA (Industry Standard Architecture) adalah

sebuah bus PC/AT (16 bit) yang beroperasi pada

8,33 MHz BUS PCI

Bus PCI (Peripheral Component Interconnect bus)

Bus yang beroperasi pada kecepatan 33 MHz

BUS Seri Universal

Sebuah bus standart yang disepakati bersama oleh tujuh perusahaan untuk digunakan pada peralatan

berkecepatan rendah

What is BUS ?

A bus connects all the internal computer components to the CPU and Main memory.

Every bus has a clock speed measured in MHz. A fast bus allows data to be transferred faster, which makes applications run faster. On PCs, the old ISA bus is being replaced by faster buses such as PCI.

• BUS adalah Jalur komunikasi yang dibagi pemakai Suatu set kabel tunggal yang digunakan untuk menghubungkan berbagai subsistemBUS Sistem adalah Sebuah Bus yang menghubungkan komponen-komponen utama komputer (CPU, Memori ,I/O)

I/O BUS

System Bus: Connecting to CPU, memory and Cache. Address Bus Data Bus Control Bus

I/O Bus: Connecting to the above three buses is the "good old" standard I/O bus, used for slower peripherals (mice, modems, regular sound cards, low-speed networking) and also for compatibility with older devices. On almost all modern PCs this is the Industry Standard Architecture (ISA) bus.

System Bus

BUS DATA

- Saluran data memberikan lintasan bagi perpindahan data antara dua modul sistem .

- Besar jalur bus data mempengaruhi kinerjanya, contoh : 8, 16, 32 dan 64 bit

Bus Alamat

- Identifikasi sumber atau tujuan data pada bus data

- Mengalamati port-port I/O

- Contoh : jika CPU akan membaca word ( 8, 16 atau 32 bit) data dari memori maka CPU akan menaruh alamat word yang dimaksud pada saluran alamat

Bus Kendali

- Mengontrol akses ke saluran alamat dan

penggunaan data dan saluran alamat.

- Mengendalikan dan mengatur timing informasi :

a. Sinyal read /write

b. Interrupt request

c. Sinyal clock

“I/O bus”“Bus interface”“CPU bus”

or“System bus”

CPU-Memory-I/O Architecture

CPUI/O

module

Memory

I/O device

Types of I/O Buses

ISA

Micro Channel (MCA)

EISA

VESA Local bus (VL-bus)

PCI Local bus

AGP

PC-Card (PCMCIA)

USB

Fire Wire (IEEE-1394)

ISA BUSBus ISA (Industry Standard Architecture) adalah sebuah arsitektur bus dengan bus data selebar 8-bit yang diperkenalkan dalam IBM PC 5150 pada tanggal 12 Agustus 1981. Bus ISA diperbarui dengan menambahkan bus data selebar menjadi 16-bit pada IBM PC/AT pada tahun 1984, sehingga jenis bus ISA yang beredar pun terbagi menjadi dua bagian, yakni ISA 16-bit dan ISA 8-bit. ISA merupakan bus dasar dan paling umum digunakan dalam komputer IBM PC hingga tahun 1995, sebelum akhirnya digantikan oleh bus PCI yang diluncurkan pada tahun 1992.

I/O BUS

ISA BUS (8-16-bit) EISA (Extended Industry Standard

Architecture) BUS (32-bit) PCI (Peripheral Component Interconnect)

BUS (32 or 64-bit) AGP (Accelerated Graphic Port)

(32-bit)

ISA BUS

8-bit 16-bit

ISA BUS

Bus width 8 - bit

Compatible with 8 bit ISA

Pins 62

Power +5 V, -5 V, +12 V, -12 V

Clock 4.7727266 MHz

Bus width 16 - bit

Compatible with 16 bit ISA

Pins 98

Power +5 V, -5 V, +12 V, -12 V

Clock 8.333333 MHz

8-bit ISA BUS 16-bit ISA BUS

ISA BUS

is used with sound cards, disk drives or most network and video cards.

8-bit ISA(XT) CARD 16-bit ISA CARD

ISA BUS

ISA Card

ISA BUS

Original 8 bit ISA connectors

Additional connections converts to 16 bit ISA

VESA connectors

3 ISAslots

5 PCI slotsPentium

CPU6 SIMMslots

2 DIMM slots

ISA BUS

In the figure you can see the pinouts of the ISA BUS. The BUS is divided into two sides. The first side pins are named A1 to A31 and it is the components side. It consists of the address and data buses. The second side pins are named B1 to B31 and it is the solder side. This side contents the power pins and the signals related to interrupts and DMA transfers.

ISA BUS

20 bits of Address bus

± 5, ±12V Power & G

IRQ lines 2-7

IRQ lines 8 - 15

Extra 8 bits of I/O bus

Extra 4 bits of Address bus

More

DMA

linesclock

Original 8 bit ISA 16 bit

More

DMA

lines

8 bits of I/O bus

ISA BUS A0-A19 (pins A31 to A12): This twenty lines are the address BUS.They can address 1MB (2^20 bytes). D0-D7 (pins A9 to A2): The data BUS consist of this eight data lines. AEN (pin B11): It is used for the DMA controller to take over the data and address buses in a DMA

transfer.

GND (pins B1, B10, B31): Connected to the ground of the computer. +5V (pins B3, B29): 5V DC output of the power source. -5V (pin B5): -5V DC output. -12V (pin B7): -12V DC output. +12V (pin B9): +12V DC output. MEMW (pin B11): The µP asserts this signal when doing a write to the memory. MEMR (pin B12): The µP asserts this signal when doing a read from the memory. IOW (pin B13): The µP asserts this signal when doing a write to a port. IOR (pin B14): The µP asserts this signal when doing a read from a port. DACK0-DACK3 (pins B15, B17, B19 and B26): The DMA controller sets this signals to let a device know

that the DMA has the control of the buses.DRQ1-DRQ3 (pins B6, B16 and B18): Allow the peripheral boards to request the use of the buses.+T/C (pin B27): The DMA controller sets this signal to let the peripheral know that the programmed number of bytes has been sent.IRQ2-IRQ7 (pins B4, B21, B22, B23, B24 and B25): Interrupt signals. The peripheral devices sets this signals to request for the attention of the µP.ALE (pin 28): This signal is used for the µP to lock the 16 lower address BUS in a latch during a memory (or port) input/output operation.CLOCK (pin 20): Is the system clock.OSC (pin 30): Is a high frequency clock which can be used for the I/O boards.

Describing the Read operation of the ISA

CPU sends out a high on the ALE signal, then sends out the A0-A19 lines. On the address of the target port to be read will be latched. Then the BUS takes the -IOR signal to a low level. So that the addressed device will take a data byte to the D0-D7 data bus. The microprocessor will read then the data bus and take the -IOR signal to a high again.

Describing the Read/Write operation of the ISA

The only difference between a memory read/write cycle and a port read/write cycle is that in a memory cycle the -MEMR and -MEMW signals will be asserted, working the same way as -IOR and -IOW do.

ISA BUS

Intel 80386DX CPU

Address bus(32 bit)

Data bus (32 bit)

A0 to A31

D0 to D31

RD WR IO/M

Control bus

I/O bus (16 bit data)

StoragePrinterVideo

Modem

Memory

Keyboard

Bus Structure of Intel 486CPU

Local bus or CPU bus: fast (33 MHz, 32 bits) [30 nsec./cycle]

Memory CacheVideo

AdapterDisk

ExpansionBus

Controller

RTC

ISA bus: slow (8 MHz, 8/16 bits) [125 nsec./cycle]

KeyboardSerialPort

ParallelPort

FloppyDisk

SystemROM

“ISA BRIDGE”

Bus Structure of Intel Pentium Pentium

CPU

CPU bus: fast (100 MHz, 64 bits) [10 nsec./cycle]

MemoryCache

VideoAdapter

SystemROM

ExpansionBus

Controller

RTC

ISA bus: slow (8 MHz, 8/16 bits) [125 nsec./cycle]

KeyboardSerialPort

ParallelPort

FloppyDisk

PCIController

PCI bus: fast (33 MHz, 32/64 bits) [30 nsec./cycle]

Disk

“North Bridge”

“South Bridge”

Bus Structure of Intel Pentium

ExpansionBus

Controller

M/IO #(memory or i/o address)

D/C# (Data or code)

W/R# (Write or Read)

AEN#

A31-A3 (Address Lines)

BE7# - BE0# (Byte Enable Lines)

CLK

BRDY# (Burst Ready)

CPU Bus PCI Bus

AD[31:0]

C/BE#[3:0]

FRAME#

TRDY#

IRDY#

STOP#

REQ#

GNT#

D31-D0

NORTH BRIDGE

Bus Structure of Intel Pentium

ExpansionBus

Controller

CLK

MEMR#

MEMW#

IOR#

IOW#

INTA#

A23-A0

PCI Bus ISA Bus

AD[31:0]

C/BE#[3:0]

FRAME#

TRDY#

IRDY#

STOP#

REQ#

GNT#

D23-D0

SOUTH BRIDGE

ALE

ISA BUS INTERRUPT SYSTEM 16-bit ISA bus chains two 8259As together. IRQ 9 is used to re-route anything trying to

use IRQ 2. Incorporated in chip set.

INTERRUPT CONTROLLER

80x86

INTR

8259A

IRQ0IRQ1IRQ2IRQ3IRQ4IRQ5IRQ6IRQ7

8259A

IRQ0 (8)IRQ1 (9)IRQ2 (10)IRQ3 (11)IRQ4 (12)IRQ5 (13)IRQ6 (14)IRQ7 (15)

(IRQ 2)

Elimination of ISA Bus

ISA Bus is slow, hard to use and bulky. ISA plug in cards to be replaced by either PCI

plug-in cards or USB add-on peripherals Limited number of interrupts. No central registry.


The ISA bus is limited to 24 bits of address. 2^24 = 16 MBytes. It means that an ISA card that uses DMA cannot physically access memory beyond 16 MBytes of RAM. This is a limitation of the ISA bus.


Motherboard gets 32-bit data from ISA BUS at two times. Meanwhile at this time ISA BUS declares “wait state” to the motherboard. Therefore ISA BUS may reduce System Performance.


If you use a ISA based controller card such as Ultra SCSI - 40Mb / sec or SCSI-2 Fast - 10 Mb / sec , you can expect no more than an 8Mb per second transfer rate from your controller card.


PCI cards have “Plug and Play” technology and can configure themselves, so Operating Systems distinguish them.

ISA cards are more cumbersome to install than other cards because I/O addresses, interrupts and clock speed must be set using jumpers and switches on the card itself.

Elimination of ISA BusBus Type MB/sec

VL-bus 100 MBps

VL-bus 132 MBps

32-Bit PCI 132 MBps

PCI-X 66 512 MBps

PCI-X 133 1 GBps

AGP x1 264 MB/s

AGP x2 528 MB/s

AGP x4 1056 MB/s

AGP x8 2112 MB/s

PCI Express x1 500 MB/s






isa bus (industry standard architecture). tipe-tipe bus bus isa bus isa (industry standard...

Documents