k-tv02 rc- radio ontrolli
TRANSCRIPT
RC-
Radiocontrolli s.r.l refuses any responsibility for irregular uses of the devices and for any possible lack or inaccuracy of the data and reserves the right to change in whole or in part these information without notice. Rev 1.1
Pag. 1 / 2
Radio Wireless Modules
ontrolli
www.radiocontrolli.com
K-TV02
RX-Multi Receiver Unit
External Antenna
Learning buttons
CH2CH1Power Supply DIPSWITCH
RCTV-02 Remote Control
RCTV-02 is a 2 channels keyfob transmitter with SAW oscillator and HCS300 rolling code encoder.
Manufactoring code = RadioControlliCR2032 (3V Battery)
anti-humidity seal
Mechanical dimension : 52x30mm
Receiver Unit 433,92MHz 2 channels Relay Output
K-TV02 is a kit composed by a 2-channels receiver unit (RX-Multi) operating at a frequency of 433.92MHz with AM modulation and No. 2 RCTV-02 remote control.
+ 2 Remote Control
This receiving unit can work with an input voltage of AC / DC9-30Volt.The device works in the following frequency range:- 300-868MHz with AM modulation.
With the 8 position DIPSWITCH switch, different types of remote control can be selected, in this case only the RCTV-02 remote control by RadioControlliwill be accepted.
This Receiver unit has two independent output channels CH1 and CH2; Each channel has its own learning button K1, K2.Mechanical dimensions: 125x75x35mm.
Radiocontrolli s.r.l refuses any responsibility for irregular uses of the devices and for any possible lack or inaccuracy of the data and reserves the right to change in whole or in part these information without notice. Rev 1.1
Pag. 2 / 2www.radiocontrolli.com
Learning Procedure :
RC- Radio Wireless Modules
ontrolli K-TV02
Antenna
DISPLAYK1 button
DIP SWITCH
Erasing Memory Procedure:
1) Press and hold the K1 button for about 10 seconds
2) The display will turn on and after it will turn off, this means that all previously stored remote controls have been deleted from the memory.
Operating Mode:
Press the button on the remote control, the corresponding relay will be actived (output CH1 or output Ch2 closed).
Each activation is signaled with the display lighting.
The operating mode is : MONOSTABLE
When I press the button (on the remote control) the corresponding contact (CH1,CH2) will be closed (activaction) for the time that the button is pressed.
When I release the button, the corresponding contact (CH1,CH2) will open (disactivation).
1) Power the Receiver Unit (AC / DC voltage from 9 ÷ 30Volt)
2) Configure the dip-switches as shown in the picture (4 ON)
3) Press K1 button
4) The display will light up for about 15 seconds, while the display is on, press the remote control button that you want to associate at channel CH1.
5) A double flashing will indicate that the association has been carried out.
6) Proceed with the same procedure for the K2 button and CH2 channel.
7) Repeat the same operation for all the remote controls that you want to associate. It’s possible to associate up to 10 remote controls.
The remote controls included in the package are ready to be used, the learning procedure has already been done..