line voltage wiring - nti boilers start... · quick start guide trinity │tft 60-399 2 | * it is...
TRANSCRIPT
NY Thermal Inc. Tel: (506) 657-6000 Toll Free: 1-800-688-2575 Fax: 1-506-432-1135 Web: www.nythermal.com Email: [email protected]
S:\NTI2001_N_Drive (1-20-09)\MANUAL\Current manuals (doc)\NTI Manuals\Gas - Trinity & Matrix\Trinity\Trinity Tft\Quick Start Guide TFT60-399 V.2013-09-26.doc
Pump A operates during DHW demands. See low voltage wiring and DHW Demand Switch. ).
Pump B operates during all demands, both DHW and Central Heat.
Pump C operates during Central Heat demands. See low voltage wiring and Room Thermostat.
Central Heat End Switch or
Room Thermostat Demand at CH1.
Outdoor Sensor Refer to Section 12 in the TFT manual
for detailed settings.
DHW Tank Sensor or Tank Aquastat demand switch.
Low Voltage Wiring
Line Voltage Wiring
Quick Start Guide Trinity │Tft 60-399
2 |
�
* It is the Installer’s responsibility to choose an appropriate set point.
Heating System Type Fin Tube Baseboard Cast Iron Radiators In Floor Radiant
Application High Temp Medium Temp Low Temp
Temp Ranges 160F - 190F 135F - 155F 100F - 130F
Navigating the Touch Screen Display
Central Heat Settings
Change the default Setpoint to match the Heating System Type (see table below).
�LCI = CH1 Thermostat input. See manual for options. � Next Page.
�
�
��
�
Touch to return to previous screen
Return to the Config Menu once settings have been changed.
4
�Touch to return to Home screen
3
�� �
Date/Time
�
Touch
Home
� �
Change settings in a Config Group by
selecting it from the Configuration Menu.
� Summary Config Menu
Trinity │Tft 60-399 Quick Start Guide
| 3
Outdoor Reset Settings
Domestic Hot Water Settings
��
��
Touch to login in. Password = sola
�DHW (S6) = Aquastat. Login required
if changing demand to a Tank Sensor.
�
Tank On/Off temperatures (tank sensors only)
If using a tank sensor, select DHW sensor with On/Off temps Press OK to accept the change.
�
Warm Weather Shutdown Settings
��
� �Change setpoint
�4
Touch 2x to return to Summary screen
Touch to return to previous screen
Return to the Config Menu once settings have been changed. 5
�
� Heating System Type Fin Tube Baseboard Cast Iron Radiators In Floor Radiant
Temp Ranges 110F - 125F
90F - 110F 70F - 85F
�
Change the default Low Water Temp to match the Heating System Type (see table below). �3
Touch to select “Shutdown immediately”
�
Quick Start Guide Trinity │Tft 60-399
4 |
Wall Mounting | Common
OUTLET
A I R
F L U E
I N LET
GAS
Water and Gas can be connected at the bottom or top of the unit.
A I R
F L U E
I N LET
OUTLET
GAS
Water and Gas can be connected at the bottom or top of the unit.
OUTLET
I N LET
F L U E
G A S
A I R
Water and Gas can be connected at the bottom or top of the unit.
Tft60-110 Connections Tft300-399 Connections Connections Tft155-250
VERY, VERY IMPORTANT !!! Install the Condensate Trap See Section 6.0 in the Tft Manual