1 of 24 25051DO611V8

Advisory Section

To ensure the safety of you, the installer, and your children, it is important that these instructions are read fully before commencing the positioning and installation of this product.

ASSEMBLY INSTRUCTIONS

for children 18+ months, maximum weight 40Kg.

Assembly requires 2 adults (approx. 1 hour assembly time)

Warning: not suitable for children under 36 months until fully assembled due to small parts

For Outdoor Domestic Use Only

Little Gardener’s Cottage

25051

2 of 24 25051DO611V8

Safety This product has been designed and tested to rigorous European Safety Standards to ensure the safety and security of children using this product.

It has been designed and manufactured for:

Installation by adults only. You will need an adult helper to assist with some parts of the installation.

Domestic family, outdoor use only and must not be installed within a public area such as a school, public house garden, communal play area, etc.

Children aged over 18 months old whilst being supervised by a responsible adult.

Installation on a flat surface (slope less than 2%), otherwise there may be a risk of instability

Installation on a suitable surface (i.e. it should not be installed over concrete, asphalt, tarmac or any other hard or broken surface)

Use within a clear area where the nearest obstruction (fence, tree, laundry line, cable, etc.) is more than 2 metres away. This distance should be measured from the furthest point of the play set (i.e. the bottom of any slide or a swing at maximum extension)

Finally, the safety of children using this product is your responsibility. It is advised that children are supervised at all times. Do not allow children to wear loose articles of clothing (i.e. tassels or loose hair) when using item else a possible entrapment may occur. Care must be taken to use the equipment for its intended purpose, i.e. do not allow children to climb onto items not designed for that purpose, as injury may result.

Timber Advice This product has been made from premium timber. Great care has been taken in selecting, treating and machining the timber before it is presented to you. Timber is a natural product and as such may experience changes throughout the course of its life. This means it may:

Develop openings (gaps, slits, apertures, cracks, splits) along the line of the grain. These openings are due to the difference in moisture content between the internal and outer surfaces of the timber. This is to be expected, is totally acceptable and will not affect the integral strength, life or guarantee of the product.

Warp and distort its shape. Any distortion will be slight and will not affect the safety or enjoyment of this product.

Fade as the timber reacts with sunlight. The timber should be treated with a proprietary product to act as a protective barrier, i.e. a water repellent, on an annual basis.

Routine Maintenance It is advised that on a regular basis (i.e. at the beginning of the season and monthly thereafter) all main parts/ fixings are checked as secure, well oiled (if metallic), have no sharp points/edges and are intact. Replace, oil and/or tighten when necessary. Failure to do so may result in an injury or hazard.

Remember to keep these instructions in a safe place for future reference. Plum Products, 72 High Street, Horsell, Woking, Surrey, GU21 4SZ, UK. Tel 0844 8805302, Fax 01483 771162 Plum Products Australia Pty Ltd, PO Box 1014, Spit Junction, Sydney, NSW2088, Australia. Tel: 02-9960550, Helpline: 1800 900 161 Copyright Plum Products 2010

3 of 24 25051DO611V8

PARTS LIST PART ID DIMENSION WITH GRAPHIC QUANTITY

Front

1

Rear

1

Right Side Wall

1

Left Side Wall

1

4 of 24 25051DO611V8

End Gables

2

Roof Panels

2

Roof Ridge

1

Roof Ridge Ends

2

Ridge Support

1

Front Roof

Support

1

Rear Roof Support

1

Support Block

2

Front Door

1

5 of 24 25051DO611V8

Trellis

1

Trellis Front

1

Trellis Side

4

Chimney Front / Back

4

Chimney Side

2

Table Top

1

6 of 24 25051DO611V8

Table Legs

4

Table End

2

Table Brace (Short)

2

Table Brace (Long)

1

Bolt 60mm

8

Bolt 80mm

4

Washer

24

Nut

12

Screw Pan Head

19mm

2

Screw Flat Head

25mm 29

Screw Flat Head

30mm

34

Screw Flat Head

40mm

12

7 of 24 25051DO611V8

TOOLS REQUIRED:

10mm

8 of 24 25051DO611V8

1

2

60mm

9 of 24 25051DO611V8

3

19mm Pan Head x2

4

10 of 24 25051DO611V8

5

6

60mm

11 of 24 25051DO611V8

REPEAT STEP FOR OTHER SIDE WALL

5 4

7

6 7

8 80mm

2

12 of 24 25051DO611V8

REPEAT STEP FOR REAR BLOCK

10

40mm x 2

30mm x 1

9

10

13 of 24 25051DO611V8

REPEAT STEP FOR OTHER ROOF PANEL

11

RE

11

RE

12RE

40mm x 2

30mm x 1

25mm x 4

14 of 24 25051DO611V8

13RE

40mm x 2

14RE

25mm x 5

15 of 24 25051DO611V8

15RE

40mm x 2

16RE

25mm x 2

40mm x 2

16 of 24 25051DO611V8

REPEAT STEP FOR OTHER END

17RE

25mm x 2

16RE

17RE

18RE

40mm x 4

17 of 24 25051DO611V8

REPEAT STEP FOR OTHER SIDE WALL

19RE

25mm x 1

20RE

25mm x 1

19RE

20RE

18 of 24 25051DO611V8

21RE

22RE

25mm x 4

30mm x 6 Fixing

19 of 24 25051DO611V8

23RE

30mm x 2

REPEAT STEP FOR OTHER LEGS 23RE

20 of 24 25051DO611V8

30mm x 4

REPEAT STEP FOR OTHER END 24RE

25RE

30mm x 4

24RE

21 of 24 25051DO611V8

26RE

40mm x 2

22 of 24 25051DO611V8

27RE

23 of 24 25051DO611V8

24 of 24 25051DO611V8