KPS LPG Product Range

KP 50LPG100LPG pipe conductive Ø 50 mm, 100 m

KP LPG20SWeldable flange

KP LPG32S-NPTAdapter NPT 1” male x female

KP LPG294 x screw, nut, washer

KP LPG33S-NPTAdapter NPT 1” female x female

KP LPG34LPG fixing strap and clamps

KP LPG50LPG bending tool

KP LPG10SCompression coupling

KP LPG21S-NPTThreaded female flange NPT 1” female

KP LPG10-AS-NPTStraight insert coupling NPT 1” male

KP LPG10-AS-NPT-3/4Straight insert couplingNPT 3/4” male

KP LPG22SFlange halves for KP LPG10-BS

KP LPG10-BSStraight insert coupling

Flange

KP LPG16Flange gasket fiber

KP LPG23S-NPTElbow 90° NPT 1” male x female

KP LPG17O-ringfor LPG10-BS, NBR 70

KP LPG31S-NPTTee coupling NPT 1” 3 x female

KP LPG67Thread tape for LPG

KP LPG30S-NPTAdapter NPT 1” male x male

KPS Petrol Pipe System™

June 2012

www.kpsystem.com

Our Offices and Distributors KPS LPG Pipe System™Making fuel flow safely

CONDUCTIVITY

Permeation barrier

Polyethylene

Conductive layer

The KPS pipe is rated for 25 bar continuous pressure, well over the operating pressures usually applied.

The permeation barrier ensures that hydrocarbons do not permeate through the pipe wall.

The conductive inner layer eliminates static charging that otherwise would occur in a plastic pipe.

Corrosion-free LPG Piping The KPS LPG Pipe

Connections

Installation

All transitions from plastic to steel are made with stainless steel compression fittings. A range of fittings are available to connect or manifold pipes in a manner suitable for each specific installation.

LPG installers quickly learn how to install the KPS LPG Pipe System™. The pipe is rolled out in one continuous length from end to end, where it is connected to the tank and to the dispensers.

Pressure and tightness test is performed before backfill to ensure complete integrity of the installed system.

Training and SupportKPS provides training for all installers of the KPS LPG Pipe System™. The training can be combined with on-site support during the first installation. All certified KPS LPG installers are registered in the global KPS certification database.

Easy to InstallThe KPS LPG pipe is easily rolled out into the trenches of the station from end to end, and then connected to the tank and to the dispensers. No welding is needed.

Unique CE ApprovalThe KPS LPG Pipe System™ is the only LPG pipe that is CE approved to the European Directive 97/23/EC on pressure equipment and complies with the relevant requirements in EN 14678-2, EN 13163-1, EN 13445-3 and EN 12201.

The KPS LPG pipe is completely corrosion free. Steel pipes and other pipes may corrode both on the outside and on the inside, creating problems with particles damaging the dispensers, and possible leakages into the soil. KPS now provides a solution to this problem.

Connection with flange. The pipe is bent 90 de-grees on site using the bending tool for vertical entry under tank or dispenser.

Stainless steel elbow for horizontal entry under tank or dispenser. Transition made either with 90 degree stainless steel elbow or directly at the threaded insert fitting.

Stainless steel tee for in-line connection to dispenser.