lt-971 tx3-mdm modem module rev 0
Upload: mircom-group-of-companies-largest-independent-fire-alarm-manufacturer-in-north-america
Post on 12-Mar-2016
223 views
DESCRIPTION
TX3 Entry Panel Main Board Connect the ribbon cable, then place the board over the connector position with the four spacers. Align, and fasten into place with the four screws. Inputs 1 to 5 Microphone and Speaker Connection LED, Lamp Camera Supply and Power for TX3 LT-971 Rev 0 September 2009 Mounting Holes RS-485 Input/ Output P4 Connector located on the TX3 entry panel main board beneath the TX3-MDM module DIP Switches for Setting AddressTRANSCRIPT
LT-971 Rev 0September 2009
Model TX3-MDM Modem Module
Installation Instructions
TX3-MDM Modem ModuleThe TX3-MDM Guard Phone Module mounts above the TX3 Entry Panel Main Controller board on the bottom left hand side, using the four #6-32 screws and spacers provided. The ribbon cable from the TX3-MDM connects to the P4 connector on the TX3 Entry Panel Main board.
Connect the ribbon cable, then place the board over the connector position with the four spacers. Align, and fasten into place with the four screws.
Inputs 1 to 5 Microphone and Speaker Connection
LED, Lamp CameraSupply and Power for TX3
RS-485 Input/Output
DIP Switches for Setting Address
TX3-MDM Modem Module board mounts above the TX3 Entry Panel main board in this position and is connected to P4 via ribbon cable from the TX3-MDM module to the TX3 Entry Panel main board.
P4 Connector located on the TX3 entry panel main board beneath the TX3-MDM module
Mounting Holes
TX3-MDM
TX3 Entry Panel Main Board