lt-981 rb-md-934 tx3-cx instr rev 0
Upload: mircom-group-of-companies-largest-independent-fire-alarm-manufacturer-in-north-america
Post on 10-Mar-2016
218 views
DESCRIPTION
Figure 1: RB-MD-934 Board Replacement SIX MOUNTING HOLES FOR MAIN CARD ACCESS CONTROLLER BOARD Backbox shown without door. Disconnect any wiring and re-wire to replacement board. Unscrew the six screws that hold the existing board in place. Remove controller board from the backbox. Replace with new board RB-MD-934 and use the six screws to mount the replacement board in place. LT-981 Rev 0 September 2009TRANSCRIPT
LT-981 Rev 0September 2009
Model RB-MD-934Replacement TX3-CX Controller Board
Installation Instructions
RB-MD-934 MountingDisconnect any wiring and re-wire to replacement board. Unscrew the six screws that hold the existing board in place. Remove controller board from the backbox. Replace with new board RB-MD-934 and use the six screws to mount the replacement board in place.
Figure 1: RB-MD-934 Board Replacement
SIX MOUNTING HOLES FOR MAIN CARD ACCESS CONTROLLER BOARD
Backbox shown without door.