luz interior honda

EXPLODED VIEW

Fig. 34: Exploded View Of Damper/SpringCourtesy of AMERICAN HONDA MOTOR CO., INC.

NOTE: When compressing the damper spring, use a commercially available strut spring compressor (Branick MST-580A or Model 7200, or equivalent). According to the manufacturer's instructions.

2006 Honda Ridgeline RT2006-08 SUSPENSION Front Suspension - Ridgeline


miércoles, 30 de septiembre de 2015 10:57:02 a.m. © 2011 Mitchell Repair Information Company, LLC. miércoles, 30 de septiembre de 2015 10:57:09 a.m. Page 1 © 2011 Mitchell Repair Information Company, LLC.

DISASSEMBLY/INSPECTION

1. Compress the damper spring, then remove the self-locking nut (A) while holding the damper shaft with a hex wrench (B). Do not compress the spring more than necessary to remove the nut.

NOTE: When compressing the damper spring, use a commercially available strut spring compressor (Branick MST-580A or Model 720, or equivalent) according to the manufacturer's instructions.


miércoles, 30 de septiembre de 2015 10:57:03 a.m. © 2011 Mitchell Repair Information Company, LLC.

Fig. 35: Removing Self-Locking NutCourtesy of AMERICAN HONDA MOTOR CO., INC.

2. Release the pressure from the strut spring compressor, then disassemble the damper as shown in the EXPLODED VIEW.



3. Reassemble all the parts, except for the upper spring mounting cushion, bump stop sleeve, bump stop and the damper spring.

4. Compress the damper assembly by hand, and check for smooth operation through a full stroke, both compression and extension. The damper should extend smoothly and constantly when compression is released. If it does not, the gas is leaking and the damper should be replaced.



Fig. 36: Checking Damper Assembly For Smooth OperationCourtesy of AMERICAN HONDA MOTOR CO., INC.

5. Check for oil leaks, abnormal noises/ or binding during these tests.



REASSEMBLY

1. Install the spring mounting cushion (A) on the upper spring seat (B) by aligning the tab portion (C) on the cushion with the cutout (D) in the seat.

Fig. 37: Installing Spring Mounting Cushion On Upper Spring SeatCourtesy of AMERICAN HONDA MOTOR CO., INC.

2. Compress the damper spring. 3. Install all the parts except the damper mounting washer and self-locking nut onto the damper unit (A) by



referring to the EXPLODED VIEW.

Fig. 38: Aligning Bottom Of Spring And Stepped Part Of Lower Spring SeatCourtesy of AMERICAN HONDA MOTOR CO., INC.

4. Align the bottom of the spring (B) and the stepped part of the lower spring seat (C). 5. Align an angle of the damper bracket (A) and the tab portion (B) on the spring mounting cushion.



Fig. 39: Aligning Angle Of Damper Bracket And Tab Portion On Spring Mounting CushionCourtesy of AMERICAN HONDA MOTOR CO., INC.

6. Position the angle of the tab portion and the stud bolt (C) near the "FR" stamp on the upper spring seat as shown.

7. Install the damper mounting washer (A) and a new self-locking nut(B).



Fig. 40: Tightening Self-Locking Nut With Torque SpecificationsCourtesy of AMERICAN HONDA MOTOR CO., INC.

8. Hold the damper shaft using a hex wrench (C), and tighten the new self-locking nut to the specified torque value.



luz interior honda

Documents

damper spring

suspension ridgelinemircoles

damper assembly

damper unit

damper shaft

upper spring mounting

damper mounting washer

upper spring seat b