maintenance of traffic (mot) concepts
DESCRIPTION
Maintenance of Traffic (MOT) Concepts. MOT Training for Incident Responders in Florida. Highway Terminology. Highway Terminology. Standardized names and terms to identify specific features of any street, road, or highway where an incident may occur. Reduce confusion - PowerPoint PPT PresentationTRANSCRIPT
Module 4
Maintenance of Traffic (MOT) Concepts
MOT Training for Incident Responders in
Florida
Module 4
Highway Terminology
Module 4
Highway TerminologyStandardized names and terms to identify specific features of any street, road, or highway where an incident may occur.
– Reduce confusion– Improve the safety of responders– Make operations at the scene more
efficient
Module 4
Shoulders
• The pavement adjacent to travel lanes
• Referenced by:
– Inside or Outside
Module 4
Median• The center of the roadway
Module 4
Lane Referencing
• Numbered from outside to inside– Should not be referenced as the “slow
lane” or the “fast lane”
• Acceleration and deceleration lanes at interchanges will not be numbered except in the case of lane drops or adds
Module 4
2 13
2 31
Shoulder
Shoulder
Median
Inside
6-lane divided highway
Shoulder
Shoulder
Outside
Inside Outside23 1
2 31
Module 4Lane Drop Deceleration Lane
234 1
23 1
Inside Outside
ShoulderShoulder Shoulder Shoulder
23 1
23 1
Inside Outside
Module 4
Upstream and Downstream
• Upstream – Any area of a highway or any moving
traffic that is approaching the actual incident or activity area
• Downstream – Area that is past the incident scene
Module 4
Downstream
Upstream
IncidentIncident
Module 4
Incident Definition
Module 4
Differences in Definition
• Transportation provider definition
vs.
• Emergency responder definition
Source: FHWA, Incident Management Performance Measures
Module 4
Transportation Providers• Traffic Incident Management Handbook
defines an “incident” as “any non-recurring event that causes a reduction of roadway capacity or an abnormal increase in demand”
• The 2000 Highway Capacity Manual defines an “incident” as “any occurrence on a roadway that impedes normal traffic flow”
Module 4
Emergency Responders• Most law enforcement agencies and
emergency responders seem to define an “incident” as any event to which they are dispatched or requires a “response” or action by them.
Module 4
Types of Incidents
Module 4
Predictable
• Maintenance Activities
• Construction Activities
• Special Events
Module 4
Unpredictable
• Accidents (crashes)
• Stalled vehicles
• Spilled loads
• Weather
• Roadway failures
• Debris falling from trucks
Module 4
Incidents
• Create non-recurring traffic congestion– 60% of all congestion
• Cause secondary crashes
Module 4
Highway Standards
• Federal Highway Administration (FHWA)
• State Departments of Transportation
• Local Municipal Governments
Module 4
MUTCD
• Chapter 6I of the 2003 MUTCD
• “Control of Traffic Through Traffic Incident Management Areas”
Module 4
Major Provisions
• Classify incidents by expected durationClassify incidents by expected duration• Recommend interagency pre-planning and
management (“unified incident management”)
• “Fluorescent coral” background/black letters permitted for signs in incident traffic control zones
• Recommendations on use of Emergency Vehicle Lighting
Module 4
Incident Classification
•Level 1 – Minor–under 30 minutesunder 30 minutes
•Level 2 – Intermediate–from 30 minutes30 minutes to 2 hours2 hours
•Level 3 – Major–over 2 hoursover 2 hours
Source: TIM Handbook & MUTCD 2003 Chapter 6
Module 4
Temporary Traffic Control Zones
Module 4
Temporary Traffic Control Zones
Divided into four areas:
• Advance Warning Area • Transition Area • Activity Area• Termination Area
Module 4
Source: MUTCD 2003 Chapter 6
Advance Warning Area
TerminationArea
Shoulder Taper
Transition Area
Work Area
BufferSpace
BufferSpace
TrafficSpace
Activity Area(Hot Zone)
Advance Warning Area
TerminationArea
Shoulder Taper
Transition Area
Work Area
BufferSpace
BufferSpace
TrafficSpace
Activity Area(Hot Zone) Component Parts
of a Temporary Traffic Control
Zone
Module 4
Advance Warning Area
• First section that informs drivers about the incident area they are approaching
• Varies from a single sign or warning light on a vehicle to a series of warning signs– Examples: cones, flares, or emergency
vehicles far in advance of the actual incident (crash or fire scene)
Module 4
Transition Area
• Section of highway where road users are redirected out of their normal path – Usually involve strategic use of tapers.
Module 4
Taper
• When emergency responders use signs, cones, flares, or blocking vehicles to direct approaching traffic from the normal traffic lanes into a fewer number of open lanes
• Executed within the Transition Area of an incident scene
Module 4
Taper
Picture: Safe Parking…While Operating In or Near Moving Traffic, Texas FD
Module 4
Activity Area
• Section of the highway where the work activity takes place
• Comprises the Work Area, the Traffic Space and the Buffer Space
Module 4
Work Area
• Section of highway closed to road users and set aside for responders (workers), equipment, and material
• Usually delineated for road users by channelizing devices
Module 4
Work Area
Picture: Danger on I-95 – South Florida Sun-Sentinel.com
Module 4
Traffic Space
• Section of highway in which road users are routed through the activity area
Module 4
Buffer Space
• The area that separates road user flow from the work space or an unsafe area
• Provides some recovery space for an errant vehicle
Module 4
Incident RespondersResponders arriving at a traffic incident within 15 minutes of arrival on-scene should:
– Estimate the magnitude of the traffic incident
– Predict time duration of the traffic incident– Estimate vehicle queue length– Set up the appropriate Temporary Traffic
Control for these estimates
Module 4
Highway Safety Principles
Module 4
Stopping Sight Distance
• The distance traveled from the time a driver first detects the need to stop until the vehicle actually stops
Perception/ Reaction
Braking
Total Stopping Sight Distance
Perception/ Reaction
Braking
Total Stopping Sight Distance
Perception/ Reaction
Braking
Total Stopping Sight Distance
Module 4
Perception/Reaction Distance
• Distance traveled by a vehicle from the instant the driver sees an object to the instant the brakes are applied
Module 4
What is the typical driver’s perception/reaction time
value?• 0.5 seconds• 1.0 seconds• 1.5 seconds• 2.5 seconds 2.5 seconds • 4.0 seconds
• Be prepared for drivers who do not react . . .
Module 4
Braking Distance• Distance traveled by a vehicle from
the instant the brakes lock up until the vehicle stops
Speed (mph)
Distance (ft)
60 34665 40570 47075 540
Source: AASHTO Green Book 2001
Module 4
Total Stopping Sight Distance(based on 2.5-sec Perception/Reaction Time)
Note: Commercial vehicles require much longer distances.Commercial vehicles require much longer distances.
60 Mph 65
Mph70
Mph
Module 4
Highway Safety Personal Protective Equipment (PPE) and
Signaling Equipment
Module 4
Personal Protective Equipment “PPE”
• Section 6E.02 of the MUTCDSection 6E.02 of the MUTCD – Requires that workers shall wear bright,
highly visible clothing when working in or near moving traffic
– Fire/rescue personnel, EMS crews, law enforcement officials, and even tow truck operators
• PPE – General requirements Standard 29 CFR 1910.132 (OSHA)
Module 4
ANSI/ISEA Public Safety Vest Requirements
Source: Emergency Responder Safety Institute
Background Material
Minimum 450 in2Retroreflective/
Combined-Performance Material
Minimum Width 1.97 in Minimum Area 201 in2
The Vest shall have contiguous areas of retroreflective or
combined-performance material encircling the
torso – placed in a manner to provide 3600 visibilityANSI 207-2006 Standard
VestClass
II
Module 4
Highway Safety Vests
• All incident responders shall comply with this provision no later than November 24, 2008.
VestClass
III
Source: Federal Register / Vol. 71, No. 226 / Rules and Regulations Part 634 – Worker Visibility Sec. 634.4
Module 4
Question?• At nightAt night – how far away can a driver
see you?
Source: ANSI/ISEA 107-1999 MADE EASY. A Quick Reference to High-Visibility Safety Apparel
Average Detection DistanceLow Beams and Dark Clothing
Low Beams and White Clothing
Low Beams and ANSI Vest II or III
Visib
ility o
f Ped
estri
an at
Nigh
t Average Detection DistanceAverage Detection DistanceLow Beams and Dark Clothing
Low Beams and White Clothing
Low Beams and ANSI Vest II or III
Visib
ility o
f Ped
estri
an at
Nigh
t
Module 4
Traffic Control Devices
Module 4
Traffic Control Devices• To promote highway safety by providing
for the orderly and predictable movement of all traffic and to provide guidance and warning as needed
• Examples:– Signs– Channelizing devices– Lighting devices– Shadow vehicles
Module 4
Warning Signs
• Warning signs are used to give notice of an unexpected condition or a condition that may be potentially hazardous to traffic.
Picture: KTC, Emergency Traffic Control for Responders-Training
Module 4
Examples of TIM Area Signs
Source: MUTCD 2003 Chapter 6 Figure 6I-1
Module 4
Warning Signs - Placement
• Right- or left-hand side of roadway• As near to the edge of the road as
possible, but no closer than 2 feet• Right angles, facing traffic• No obstructions• In advance of hills and curves
Module 4
Incorrect Placement
Source: Emergency Traffic Accommodation – A Guide for First Responders
Module 4
Correct Placement
Source: Emergency Traffic Accommodation – A Guide for First Responders
Module 4
Source: Emergency Traffic Accommodation – A Guide for First Responders
IncorrectPlacement
CorrectPlacement
IncorrectPlacement
CorrectPlacement
Module 4
Channelizing Devices• Their function is to warn road users of
conditions created by work activities in or near the roadway and to guide road users
• Channelizing devices include:– cones – tubular markers– vertical panels – drums – barricades– temporary raised islands
Module 4
Traffic Control Devices
• Florida Design Standard, Series 600 requirements:
– FDOT approved number shall be engraved on the device
– Traffic control devices must be on the Qualified Product List
Module 4
Cones
• Cones shall be predominantly orange
• Shall be made of a material that can be struck without causing damage to the impacting vehicle
Module 4
Cones
• One solution to carrying 28-inch traffic cones within the limited storage space on most responders vehicles is the “collapsible” cones.
• Four 28-inch tall Pop-UpR cones only occupy a 12-inch-high stack when stored.
Picture: Safe Parking…While Operating In or Near Moving Traffic, Texas FD
Module 4
Flares
• Work well at night to warn motorists of lane changes and merges due to the bright red light they emit as they burn
• The visibility of traffic cones can be increased under night conditions by deploying flares and cones together
Module 4
Flares
When flares are placed near a traffic cone, the light given off by the flare not only warns upstream traffic but illuminates the cone as well
Module 4
Flashlights
Specially-designed orange cones that fit over the end of a flashlight to improve their usefulness for traffic control.
Module 4
Emergency-Vehicle Light• Essential in the initial stages of a
traffic incident• Provide safety to emergency
responders and persons involved in the traffic incident, as well as road users approaching the traffic incident
• Example:– high-intensity rotating, flashing, oscillating
or strobe lights
Module 4
Emergency-Vehicle Light
• In multi-lane freeways
– Recommended to “shed” or turn off all forward-facing emergency lighting that affect traffic in the oncoming lanes
– To reduce rubbernecking and prevents secondary crashes
Module 4
Minimize Lights• Avoid glare to motorists
• Turn off unnecessary lights– Emergency vehicle lighting:
• Provides warning only and provides no effective traffic control
• Can be confusing and distracting to drivers
• Use amberamber instead of red
Module 4
Picture: USFA, Traffic Incident Management System
INCORRECT
CORRECT
Module 4
Arrow Panels
• Provide additional warning and directional information to assist in merging and controlling road users through or around a Temporary Traffic Control zone
Module 4
Arrow Panels• Nighttime use
– When advance warning arrow panels are used, the intensity of the flasher shall be reduced
• Location– For lane closures on multi-lane roadways,
an arrow panel should be located on the shoulder at the beginning of the taper
Module 4
Pictures: FDOT Road Rangers Basic Training
Module 4
Source: MUTCD 2003 Chapter 6 Figure 6I-1
Module 4
Shadow Vehicles
• Shadow Vehicles – Trucks or trailers that are used to protect workers or work equipment from errant vehicles
• Heavy Vehicle – 33,000 GVWR or greater, loaded at least 20,000 pounds (tanker truck)
Module 4
Shadow Vehicle• Once parked, it becomes a traffic
control device (TCD) placed as an element of the TCZ using the MUTCD as a guide. It is:– spotted parallel with traffic 100 to 100 to
250 ft250 ft upstream from the work area depending upon the speed limit, with wheels cut toward the shoulder
– not involved in incident mitigation efforts and not occupied by people!!!
Module 4
Work Area(Incident Area)
Shadow Vehicle
If Available
Work Area(Incident Area)
Shadow Vehicle
If Available
Work Area(Incident Area)
Shadow Vehicle
If Available
Module 4
END
Question or Comments