manish ranjan
TRANSCRIPT
BABU BANARASI DASN.I.I.T
Department Of Electrical & Electronics Engineering
PRESENTATION ON
Guided By: Presented by :
Mr. Rafiq Ahmed Mr. Manish Ranjan
Head of Department B.Tech. EN Final Year
Contents
Introduction to ELECTRIC LOCO SHED, MUGHALSARAI
WORKING OF Pneumatic Section
Working of PPIO
Working of Auxiliary Section
Working of E-1 to E-4 Section
Working of M-1 to M-3 Section
Working of Pantograph
Introduction to Electric Loco Shed, Mughalsarai
There are three types of locomotives maintained in this shed. They are…
WAP4- These locomotives are used in mail and passenger trains
WAMA- These locomotives are used in passenger and goods trains
WAG7- These locomotives are used in goods trains
Pneumatic Section
This section works on air compression buildup .In this section either repairing of compression system is done or replacement of damaged system to new system is achieved.
Working of PPIO (Progress Planning & Information Organisation)
Whole electric loco shed performance and activities were controlled under section
Auxiliary SectionThis section works on the auxiliary motors and equipment , which converts single-phase into three-phase
Working of E-1 to E-4 Section
E-1 Section: In this section task related to trouble shoot is performed
E-2 Section: In this section task related to handling of electrical equipment were performed.
E-3 Section: Maintenance of traction motor comes under this section
E-4 Section: Maintenance of microprocessor and relay comes under this section.
Working of M-1 to M-3 Section
M-1 Section: This section works on locomotive structures that is wheel and bearings.
M-2 Section:Working just like M-1 section
Working of Pantograph
Pantograph is a hinged frame that holds the long collecting shoes against the wire in a fixed geometry.