manutençã duravi
DESCRIPTION
ManutençãoTRANSCRIPT
-
HAPPY D Cistern ILLUSTRATION/ FEATURES AND BENEFITS:
Taking the simple symmetry of the letter D This creates a unique design for your bathroom
Unique collection by Sieger design This assures you of excellent design throughout your bathroom
Manufactured by Duravit, one of Europes best Assurance of excellent quality
Happy Ds modern design This creates the latest contemporary feel for your bathroom
AVAILABILITY/ PRODUCT CODES:
HAPPY D CISTERN WH *CHROME PUSH BUTTON* 0910100005 NSSHDCI001
COMPATIBILITY:
HAPPY D CLOSE COUPLED PAN (SEMI BTW) WHITE 017209 HD172.09WW
HAPPY D CLOSE COUPLED PAN WHITE 0 17009 0000 SHDWCCC1
Requires a minimum of 0.5 bar to operate effectively
SUPPLIER DETAILS/PRODUCT CODES/CONTACTS:
Suppliers code 910100005
-
INSTALLATION INFORMATION/ REQUIREMENTS:
1. Remove cistern lid, Obtain chrome push button
2. Remove fill valve from clip, rubber seal and fixing kit from inside cistern
3. Depress blue clips lift flush valve from base
4. To Install cistern to pan: Fit conical washers onto screws, pass screws through holes in base of cistern, fit rubber washers and metal washers, fit and tighten nuts to seal holes. Fit large foam rubber sealing washer, mount cistern on pan, Fit stepped rubber washers, metal washers and wing nuts. Tighten wing nut to secure cistern to pan. Finger tight only: do not use pliers or other tools
5. Replace flush valve
6. Replace fill valve into the clip
-
7. Turn blue lever anti clock-wise to release lifting
8. Raise rod mechanism above top edge of cistern
9. Replace cistern lid, to position rod mechanism
10. Remove lid turn blue lever clockwise engage lifting rods
-
CARE AND MAINTENANCE INSTRUCTIONS:
A. Inlet valve maintenance Unclip blue arm f rom the rod connected to float then
twist the back of the Diaphragm anti clockwise till loose then pull to release
Remove rubber seal and carrier of the Diaphragm by pulling, separate diaphragm and carrier as shown then either rinse parts under your tap, as shown, to remove debris or if seal is damaged replace with new Diaphragm
To refit Diaphragm line up the protruding plastic guides to fit into the holes inside back of Diaphragm making sure it is inserted correctly
Reverse1above to re-fit diaphragm to valve
-
B. Flush valve maintenance
Depress blue clips to lift flush valve from base
Remove rubber seal from carrier
Rinse rubber seal under tap to remove debri s and refit, or replace rubber seal if damaged Replace flush valve in cistern
COMMON PROBLEMS & SOLUTIONS
Problem Cause Solution
Water continuously trickles into the pan
Pressure below 0.5 bar, f ill valve will not close grit /debris under discharge seal
Discharge seal worn or damaged
Remove seal and wash under tap to remove debris
Replace seal
Water continuously flows into cistern
Pressure below 0.5 bar, f ill valve will not close. Damaged diaphragm
Replace diaphragm
Fills slowly Pressure below 0.5 bar