march 2018 - bladel, the netherlands change notice · 2021. 1. 6. · dvs 2212-1 iso 9001. change...
TRANSCRIPT
© Hendor Pompen BV - the Netherlands
DVS 2212-1 ISO 9001
Change notice
March 2018 - Bladel, the Netherlands
At Hendor we are continuously working on improvement and innovation. Innovation in and for new products, but also of current products. For many years the bracket (pos. 115 in manual) of the magnetic drive pumps was made out of Polypropylene (PP).
Due to mould issues, we have been forced to make a change on the bracket of below mentioned models. The bracket material has been changed from glass reinforced PP to powder coated aluminium. For this application a special high chemical resistant powder coating was selected to ensure maximum chemical resistance.
The bracket is a support which has no contact with the liquid. Therefore, the performance and lifetime of the pump itself is not affected by this change. Both previous and new current bracket are dimensionally identical and fully inter-changeable.
The pump types involved in this modification are:• M110, M150• MX160, MX210, MX260
Please note Hendor is working on a full new range of improved magnetic drive pumps which all will be equipped with PP bracket.
Intermediate phase
Previous, not available anymore
Powder coated Aluminium bracketPP bracket
Current, new standard
© Hendor Pompen BV - the Netherlands
DVS 2212-1 ISO 9001
Change notice
April 2018 - Bladel, the Netherlands
At Hendor we are continuously working on improvement and innovation. Innovation in and for new products, but also of current products. In order to achieve greater efficiency we improved the impeller and the impeller bearings of the magnetic drive pumps. Also the construction is improved and is more robust.
The complete new assembly of impeller and bearings (pos. 100C) is dimensionally identical and fully interchangeable.
The pump types involved in this modification are:
• MX40, MX60, MX90 and MX120
107
104108
100C
100C Impeller complete104 Impeller107 Impeller front bearing108 Impeller rear bearing
NEWOLD
107
104108
100C
100C Impeller complete104 Impeller107 Impeller front bearing108 Impeller rear bearing133 O-ring134 O-ring
134
133
© Hendor Pompen BV - the Netherlands
DVS 2212-1 ISO 9001
Change notice
April 2018 - Bladel, the Netherlands
At Hendor we are continuously working on improvement and innovation. Innovation in and for new products, but also of current products. We improved the construction of the magnetic drive pumps. Instead of an injection moulded volute (pos. 101 in manual), the volute is now machined. The new machined volute is especially more robust.
The new volute is dimensionally identical and fully interchangeable.
The pump types involved in this modification are:
• M110, M150, M220, M300, M400• M150-H, M220-H, M300-H
NEWOLD