IDEAS “MAD-2014”

Mechatriks Academywww.mechatriks.in

MECHATRIKS GROUPWWW.MECHATRIKS.COM

“ACCIDENT DETECTION AND REPORTING SYSTEM USING GPS, GPRS AND GSM TECHNOLOGY”

Speed is one of the basic reasons for vehicle accident. Many lives could have been saved

if emergency service could get accident information and reach in time. Nowadays, GPS

has become an integral part of a vehicle system. This paper proposes to utilize the

capability of a GPS receiver to monitor speed of a vehicle and detect accident basing on

monitored speed and send accident location to an Alert Service Center. The GPS will

monitor speed of a vehicle and compare with the previous speed in every second through

a Microcontroller Unit. Whenever the speed will be below the specified speed, it will

assume that an accident has occurred. The system will then send the accident location

acquired from the GPS along with the time and the speed by utilizing the GSM network.

This will help to reach the rescue service in time and save the valuable human life.

Published in:

Informatics, Electronics & Vision (ICIEV), 2012 International Conference on

Date of Conference: 18-19 May 2012

“INTELLIGENT WIRELESS STREET LIGHTING SYSTEM”

We propose an innovative wireless street lighting system with optimized management

and efficiency. Wireless communication uses ZigBee-based wireless devices which allow

more efficient street lamp system management, thanks to an advanced interface and

control architecture. It uses many sensors to control and guarantee the optimal system

parameters; the information is transferred point-by-point using ZigBee transmitters and

receivers and is sent to a control terminal used to check the state of the street lamps and

to take appropriate measures in case of failure. The system allows substantial energy

savings with increased performance and maintainability.

Published in:

Environment and Electrical Engineering (EEEIC), 2012 11th International Conference on

Date of Conference: 18-25 May 2012

“A HYBRID WIRED/WIRELESS NETWORKING INFRASTRUCTURE FOR GREENHOUSE MANAGEMENT”

In this paper, the problems related to the management of a farm made up of several

greenhouses are discussed. The management of this kind of farms requires data

acquisition in each greenhouse and their transfer to a control unit which is usually

located in a control room, separated from the production area. At present, the data

transfer between the greenhouses and the control system is mainly provided by a suitable

wired communication system, such as a fieldbus. In such contexts, even though the

replacement of the wired system with a fully wireless one can appear very attractive, a

fully wireless system can introduce some disadvantages. In particular, in order to

integrate at the Data Link Layer the wireless section with the wired one, a suitable

multiprotocol bridge has been implemented. Moreover, at the Application Layer, porting

of Smart Distributed System services on ZigBee, called ZSDS, allows one to access the

network resources independently from the network segment they are connected to.

Published in:

Instrumentation and Measurement, IEEE Transactions on  (Volume:60 ,  Issue: 2 )

Date of Publication: Feb. 2011

“A DRIVING BEHAVIOR DETECTION BASED ON A ZIGBEE NETWORK FOR MOVING VEHICLES”

In this paper, a scheme of moving-vehicles behavior detection based on a Zigbee

network is proposed. Three-axis accelerometers are installed on vehicles to capture the

moving vehicle postures. A fuzzy inference system is developed to infer the six basic

states of vehicle posture, such as normal driving, left/right turning, departure, accelerate,

braking and bumping. Based on the recognition of vehicle postures, the dangerous

driving behaviours of vehicle such as serpentuate will be detected. In this paper,

the design and development of hardware, vehicle posture measurement and dangerous

driving behaviour inferences are presented and realized. Additionally, an Android APP is

developed to offer human-machine interface. The detection results and GPS information

are showed in this developed system. The system sends message to related user if

dangerous driving behavior is detected. The detected data is stored to cloud for further

application.

Published in:

Technologies and Applications of Artificial Intelligence (TAAI), 2012 Conference on

Date of Conference: 16-18 Nov. 2012

“DESIGN AND REALIZATION OF HOME APPLIANCES CONTROL SYSTEM BASED ON THE ANDROID SMARTPHONE”

The remote appliances control system based on the Android smart phone is designed and

realized. A user logs into the smart phone interface, and clicks the buttons gently to send

message commands which will be transmitted to home information center through the

GSM network. Then the ARM processor recognizes the specified command, and controls

the home appliance switches in the wireless radio frequency manner to achieve remote

control of appliances ultimately. This paper focuses on the design of Android terminal, the

communication between ARM and GSM module, the realization of the wireless module

device's driver, the difficulty in supplying the appropriate low-voltage DC for MCU and

wireless module just by a single live wire. The system has the features of easy installation

and low cost, and the hardware and software can be customized and extended. What's

more, the users can manipulate appliances anytime, anywhere, letting our houses

become more and more automated and intelligent.

Published in:

Control Engineering and Communication Technology (ICCECT), 2012 International Confe

rence on

Date of Conference: 7-9 Dec. 2012

“ZIGBEE BASED INTELLIGENT HELMET FOR COAL MINERS”

A cost effective ZigBee-based wireless mine supervising system is presented in this

article. This scheme used intelligent helmets as voice terminal and ultra-low-power nodes

of wireless sensor network.The programme adopted ZigBee wireless technology to build

wireless sensor networks, realized real-time surveillance with early-warning intelligence

on methane, temperature, humidity in mining area, and used speech communication to

reduce potential safety problems in coal production.

Published in:

Computer Science and Information Engineering, 2009 WRI World Congress on  (Volume:3

)

Date of Conference: March 31 2009-April 2 2009

“DETECTING AND MITIGATING DRIVER DISTRACTION WITH MOTION CAPTURE TECHNOLOGY: DISTRACTED DRIVING WARNING SYSTEM” Distracted driving contributes to a significant portion of vehicle accidents and deaths. To

mitigate distracted driving, the University of Virginia Center to Promote Effective Youth

Development sponsored the development of a noninvasive system to detect and warn

drivers of their distraction. This distracted driving warning system is installed in the

medium-fidelity driving simulator of the Virginia Driving Safety Laboratory (VDSL). The

system is composed of (i) the Microsoft Kinect motion sensing hardware for tracking

head and skeletal movements and (ii) a custom software application for identifying four

distractions and outputting audio alerts. The system is able to identify (a) reaching for a

moving object, (b) talking on a cell phone, (c) personal hygiene, and (d) looking at an

external object. To recognize these distractions, the algorithms for (a), (b), and (c) use the

relative distances between spatial locations of various skeletal joints, and the algorithm

for (d) use the yaw, pitch and roll of the head.

Published in:

Systems and Information Engineering Design Symposium (SIEDS), 2013 IEEE

Date of Conference: 26-26 April 2013

“DESIGN AND CONSTRUCTION OF AN AUTOMATIC SOLAR”

Renewable energy resources are getting priorities in the whole world to lessen the

dependency on conventional resources. Solar energy is rapidly gaining the focus as an

important means of expanding renewable energy uses. Solar cells those convert sun's

energy into electrical energy are costly and inefficient. Different mechanisms are applied

to increase the efficiency of the solar cell to reduce the cost. Solar tracking system is the

most appropriate technology to enhance the efficiency of the solar cells by tracking the

sun. A microcontroller based design methodology of an automatic solar tracker is

presented in this paper. Light dependent resistors are used as the sensors of the solar

tracker. The designed tracker has precise control mechanism which will provide three ways

of controlling system.

Published in:

Electrical and Computer Engineering (ICECE), 2010 International Conference on

“MODELING AND APPLICATION OF WIND-SOLAR ENERGY HYBRID POWER GENERATION SYSTEM BASED ON MULTI-AGENT TECHNOLOGY”

Agent technology is further development of artificial intelligence (AI). Multi-agent system

is an agent society made up of several agents. By the collaboration of multi-agent, it can

optimize control system and enhance its intelligence and reliability. Wind and solar energy

hybrid power generation is a novel and promising power system. Randomicity and

complexity of the climate make wind and solar hybrid power generation system a

complicated system. In this paper, we first introduce advanced agent technology into wind

and solar energy hybrid power generation system, establish the wind and solar energy

hybrid power generation multi-agent system (WSHGMAS) and analyze multi agents'

collaboration relationship. At last, by the agent' application in WSHGMAS, it can realize

sea-island, remote region, unmanned operation' wind-solar energy hybrid power

generation system and enhance power system' intelligence and reliability.

Published in:

Machine Learning and Cybernetics, 2009 International Conference on (Volume:3 )

“ANTI THEFT AND MONITORING SYSTEM OF STREET LAMP POWER CABLES “

A novel anti-theft and monitoring method of street lamp power cables is presented in the

paper. The method is based on capacitance current resonance measurement principle. A

current signal with frequency varying is injected to the street lamp power system, then the

resonance frequency can be found The equivalent capacitance and the length of the cable

can be calculated. Whether the cable is stolen or not can be judged, and the fault location

can be calculated. The novel method is no necessary to add equipment to the end of

street lamp power cables, and it's not influenced by power transformer types and the

cable length. Simulation experimentations are carried out. Simulation results show that

the method is simple and correct.

Published in:

Power and Energy Engineering Conference, 2009. APPEEC 2009. Asia-Pacific

“DESIGN AND DEVELOPMENT OF GPS/GSM BASED VEHICLE TRACKING AND ALERT SYSTEM FOR COMMERCIAL INTER-CITY BUSES“

In this paper we proposed the design, development and deployment of GPS (Global

Positioning System)/GSM (Global System for Mobile Communications) based Vehicle

Tracking and Alert System which allows inter-city transport companies to track their

vehicles in real-time and provides an alert system for reporting armed robbery and

accident occurrences.

Published in:

Adaptive Science & Technology (ICAST), 2012 IEEE 4th International Conference on

“ZIGBEE-BASED IR REMOTE CONTROL REPEATER AND ITS CONTROL MESSAGE FRAME FORMAT”

Many legacy consumer devices are controlled via IR remote controls. A user needs one IR

remote control per one legacy consumer device and has to guarantee the line of sight

towards legacy consumer devices. As the ubiquitous home era emerges, all home devices

are required to be controllable at anytime and anywhere. To control IR-based legacy

consumer devices regardless of the line of sight, a small ZigBee-based IR remote control

repeater is attached near the IR receiving part of a legacy consumer device. It receives the

control message via ZigBee protocol and converts the received message into IR signal

which is transmitted to the legacy consumer device. To be available for any IR-based

consumer device without any modification, it should be made universal and generalized.

In this paper we propose the IR remote control repeater and the control message frame

format applicable to all types of IR-based legacy consumer devices.

Published in:

Consumer Electronics, 2008. ISCE 2008. IEEE International Symposium on

CONTACT US @ 9894736693

Facebook: https://www.facebook.com/Mechatriks Twitter: https://twitter.com/Mechatriks LinkedIn: http://in.linkedin.com/in/mechatriks Youtube: http://

www.youtube.com/user/MechatriksAutomation Slideshare: http://

www.slideshare.net/MechatriksAutomation Blogs: http://mechatriks.blogspot.in/ Freshersworld: http

://courses.freshersworld.com/institute/Mechatriks-Automation/3569900