megapath r17 sip trunk configuration guide · megapath r17 sip trunk configuration guide page 6 of...
TRANSCRIPT
Megapath R17 SIP Trunk
Configuration Guide
Page 1 of 8
Megapath R17 SIP Trunk Configuration Guide
1. Important Notes
a. Certified with IC 4.0 SU2
b. This SIP Carrier does not support certain features:
i. TCP/TLS
ii. T.38 Faxing
iii. Delayed Media
iv. Putback (Release Link) Transfers
c. Outbound ANI has to be a number from your assigned DIDs
d. Only the “main” number needs to register to Carrier
e. A special registry setting needs placed on the configured line inside DSEditU to
allow multiple codecs to be offered in outgoing calls
2. Carrier Documentation
a. Carrier documentation can be obtained from Megapath
Configuration Steps
Line Configuration
1. Access the Interaction Administrator > [Server] – [Version] > Lines container
2. Click File > New
3. Enter a meaningful name in the Entry Name dialog
Megapath R17 SIP Trunk
Configuration Guide
Page 2 of 8
4. Enter the following information in the Line section
a. Domain Name - Externally resolvable Domain Name for use as FROM
host portion
b. Address - A number from the assigned DIDs from the Carrier for use as
FROM user portion
c. Name - ANI to appear on Caller ID
Megapath R17 SIP Trunk
Configuration Guide
Page 3 of 8
5. In the Transport section, configure the Transport Protocol as UDP
Megapath R17 SIP Trunk
Configuration Guide
Page 4 of 8
6. Enter the following information in the Authentication section
a. Authentication – enable by clicking the Check Box
b. User Name – Primary number as provided by Megapath
c. Password – Password as provided by Megapath
d. Confirm Password – Password as provided by Megapth
Megapath R17 SIP Trunk
Configuration Guide
Page 5 of 8
7. In the Proxy section click Add and enter carrier’s provided IP & Port, click OK
8. Repeat step 7 for any other IP addresses provided for redundancy
9. In the Registrar Section click Add under the External Phone Numbers list box,
enter the number used in Step 6, click OK
Megapath R17 SIP Trunk
Configuration Guide
Page 6 of 8
10. Click ADD under the Prioritized list of Registrar addresses, enter the IP from Step
7, click OK
11. Repeat step 10 for each Proxy entered at Step 8
12. In the Access section set “All computers will be:” to Denied Access
13. Click Add and enter the IP Address of the carrier’s Proxy, click OK
Megapath R17 SIP Trunk
Configuration Guide
Page 7 of 8
14. Repeat step 13 for each IP entered in Step 8
15. Click OK to close the Line Configuration dialog
16. Click Start > Run > Enter DSEditU > Click OK
17. Navigate to <Root Entry> > S > Production > [Server Name] > Lines >
[LineName]
18. Click on any Attribute on the right hand side, click Attribute > Add Attribute…
19. Enter “Offer Multiple Codecs” for the Attribute name, without quotes
20. Click Add Value…
Megapath R17 SIP Trunk
Configuration Guide
Page 8 of 8
21. Enter “Yes”, without quotes, case specific, Click OK
22. Click OK to close the Edit Attribute dialog