SFLI/FMSSafety Fast Lite Hanger and FMS Strap

One piece hanger for supporting joistsfrom masonry walls.

WC-MW-2016

JHMMasonry Joint Hanger HJHMHeavy Duty Masonry Hanger

HIUBHeavy Duty Face Fix Hanger

IUB/SDSFace Fix Hanger with Screws IUBSAdjustable Skew

Joist Hanger

Heavy duty masonry hanger available with skew angle from 5° to 90°.

RHMSKSkewed Masonry Hanger

HESHeavy Engineered Restraint Strap ZS47Slotted Z-Clip

Enhanced performance for the IUB can be achieved using SDS screws.

MJCMultiple Joist Connector

Where applicable, the products shown above comply with Construction Product Regulations.

See the current catalogue for fastener and load information.Visit: www.strongtie.co.uk Tel: 01827 255600 | Fax: 01827 255616

Simpson Strong-Tie®, Winchester Road, Cardinal Point, Tamworth, Staffordshire, B78 3HG

Heavy duty support for multiple metal web membersand high load capacity applications.

METAL WEBJOIST CONNECTORS

Site skewable metal web joist hanger.Can be skewed from 5° to 67° left or right.

Support joist and provide restraint without the need for 3 courses of blockwork.

Heavy duty support for joists from masonry walls.

LITBLite Top Flange Joist Hanger

Eliminates the need for backer-blocks when supported from a metal web joist header.

IUQMetal Web Joist to SIP Hanger SFJCSafety Fast

Joist CapIUCFace Fix Concealed Flange HangerSAEFace Fix

Timber Hanger

Nailing Identification

Dome NailingThis feature guides the nail

into the joist and header at a 45° angle

Double Shear NailingThe nail is installed into the joist and header, distributing the load through

two points on each joist nail forgreater strength

Positive Angle NailingProvided when wood splitting

may occur and to reduce installation time.

Speed ProngsUsed to temporarily position and

secure the connector for easier and faster installation.

Helps eliminate air leakage where joists are builtinto masonry walls.

Heavy duty face fix hanger with bolt option foreven greater performance requirements.

Concealed flange hanger suitable for cornerdetails or where joists are close together.

FastenersRound Hole: To fasten a connector. Always fill and make sure to use the correct nail.

Hexagonal Hole: For use with SDS, SDWstructural screws.

Triangle Hole: Sometimes provided in addition to round holes. Fill triangular holes when specified.

Obround Hole: Provide easier nailing access in tight locations. Fasteners installed at any angle.

Diamond Hole: Optional holes to temporarily secure connectors to the member during installation.

4.0x100 3.75x75 3.35x50 3.75x300 mm

30 mm

75 mm

100 mm

50 mmStainless

Steel

Square Twist

Allows metal web joists to be face fixed to a structural insulated panel (SIP).

An engineered solution to fixing timber noggings to joists to support the floor.

Structural Screws available in lengths up to 400mm. No pre-drilling necessary.

Allows two metal web joists to come togetherto act as a single unit.

HES can be installed placed above the joist without the need for notching.

SDW/ESCRStructural Screws

A ( 0.25 )

A

A

-

A