mounting instructions abt-llk für mqb - audi tt rs · mounting instructions abt-llk für mqb -...
TRANSCRIPT
Mounting InstructionsABT-LLK für MQB - Audi
TT RSAudi TT RS
© 2017 ABT Sportsline GmbH version: 1.0.0created: 04.09.2017
page 2/12 © 2017 ABT Sportsline GmbH
Mounting Instructions ABT-LLK für MQB - Audi TT RS
Table of contents................................................................1 Hints 3
................................................................2 Scope of delivery 4
................................................................3 Prepations at the vehicle 5
................................................................4 Intercooler Installations 10
................................................................5 Completion 11
© 2017 ABT Sportsline GmbH page 3/12
Mounting Instructions ABT-LLK für MQB - Audi TT RS
1 Hints
Mounting Instruction ABT LLK für MQB
Vehicles: Audi TT RS
Assembly time: approx. 75 minutes
© 2017 ABT Sportsline GmbHpage 4/12
Mounting Instructions ABT-LLK für MQB - Audi TT RS
2 Scope of delivery
Please check the completeness of delivery before starting theinstallation. In case the delivery is incomplete, please contact ABTSportsline GmbH.
Quantity Picture Description
1 ABT intercooler
1Bracket for outsidetemperature sensor
1wiring harness for outsidetemperature sensor
1 lens head screw M5x12
© 2017 ABT Sportsline GmbH page 5/12
Mounting Instructions ABT-LLK für MQB - Audi TT RS
3 Prepations at the vehicle
Remove the original intercooler asspecified by the manufacturer.
Remove the marked area bysawing/grinding. It´s located onthe left side in driving direction ofthe lock support.
Remove the air duct on the leftand the right side.
© 2017 ABT Sportsline GmbHpage 6/12
Mounting Instructions ABT-LLK für MQB - Audi TT RS
Remove the outside temperaturesensor and cut the air duct onthe marked point as shown inthe picture.
Reassemble the air duct to thecar.
- Overall view
© 2017 ABT Sportsline GmbH page 7/12
Mounting Instructions ABT-LLK für MQB - Audi TT RS
Replace the cable of the outdoortemperature sensor with theenclosed cable set.
Lay the cable in the direction ofthe lock carrier so that the cableof the outside temperature sensoris guided through the gap of theventilation hose.
© 2017 ABT Sportsline GmbHpage 8/12
Mounting Instructions ABT-LLK für MQB - Audi TT RS
Fix the supplied holder 4 cm fromthe marked line to the bottomedge of the holder and drill a 3.5mm hole.
Now mount the enclosed holderwith the M5x12 head screw sothat the outside temperaturesensor is protected behind thelock support. Fit the outsidetemperature sensor in the holderand connect it to the installedcable.
Remove the marked styrofoamparts.
1 - Saw the marked part of thestyrofoam off.
© 2017 ABT Sportsline GmbH page 9/12
Mounting Instructions ABT-LLK für MQB - Audi TT RS
2 - Saw the marked part of thestyrofoam off.
After the work is donereassamble both styrofoam partsto the front apron again.
© 2017 ABT Sportsline GmbHpage 10/12
Mounting Instructions ABT-LLK für MQB - Audi TT RS
4 Intercooler Installations
Mount the ABT intercooler asspecified by the manufacturer.
© 2017 ABT Sportsline GmbH page 11/12
Mounting Instructions ABT-LLK für MQB - Audi TT RS
5 Completion
Replace all the parts to the vehicle.
Read out the error memory and delete if necessary.
Start the engine and take a test drive.
ABT Sportsline GmbH
Johann-Abt-Str. 2
D-87437 Kempten / Allgäu
Phone: +49 (0)831 / 57140 - 0
Fax: +49 (0)831 / 72666
Email: [email protected]
www.abt-sportsline.de