nam rime factor and ice accumulation rate faye barthold — hmt meteorologist mike bodner — dtb...

Download NAM Rime Factor and Ice Accumulation Rate Faye Barthold — HMT Meteorologist Mike Bodner — DTB November 4, 2009

If you can't read please download the document

Upload: sammy-conde

Post on 14-Dec-2015

221 views

Category:

Documents


0 download

TRANSCRIPT

  • Slide 1

NAM Rime Factor and Ice Accumulation Rate Faye Barthold HMT Meteorologist Mike Bodner DTB November 4, 2009 Slide 2 What is rime factor? Defined as the total growth of ice by vapor deposition and accretion divided by the growth of ice by vapor deposition alone Indicates the amount of riming present on an individual ice particle Derived directly from the models microphysics scheme Currently available in the NAM (Ferrier microphysics) only Slide 3 Rime Factor 1.0 >1 to ~2 ~2 to ~4 ~4 to ~8 ~8 to ~40 >40 Hydrometeor Type Unrimed snow Lightly rimed snow Moderately rimed snow Heavily rimed snow GraupelSleet Snowflake images from: http://www.its.caltech.edu/~atomic/snowcrystals/ Slide 4 Ice Accumulation Rate Can derive an ice accumulation rate in inches per hour using rime factor value in the lowest layer of the model Median point between the surface and the interface with the next layer Combines snow and precipitation ice Does not give information about freezing rain rates Slide 5 Ice Accumulation Rate Algorithm depends on an assumption of a maximum possible snow to liquid ratio Where: IAR = ice accumulation rate PRATE = precipitation rate POFP = percent of frozen precipitation DR = density ratio FRIME = rime factor Slide 6 Ice Accumulation Rate Assuming a 30:1 maximum snow to liquid ratio Assuming a 20:1 maximum snow to liquid ratio Assuming a 10:1 maximum snow to liquid ratio Slide 7 Limitations Doesnt take ground temperature or surface heat flux into account Accumulation rates will always increase as the assigned snow to liquid ratio increases Model doesnt make any decision about whether a given snow to liquid ratio is realistic Instantaneous value onlydoesnt capture what happens at intermediate time steps Based on NAM QPF, temperature profile, etc. If NAM sounding and temperature forecasts are questionable, rime factor and ice accumulation rate forecasts will also be questionable Slide 8 Cases Used CoCoRaHS new snow reports to determine usefulness of ice accumulation rate output October 2008northern Rockies snowstorm December 2008eastern U.S. mixed precipitation event January 2009southern plains to northeast US winter storm Slide 9 October 2008 Early season mountain snow event Snowfall totals (maximum observed) State Snow (in) Montana49 Wyoming33 North Dakota 11 South Dakota 12 Idaho15 Utah11 Slide 10 Slide 11 30:120:110:1 Slide 12 Slide 13 Slide 14 December 2008 East coast mixed precipitation event Snowfall totals (maximum observed) State Snow (in) Texas5 Louisiana8 Mississippi8 Kentucky6.5 Pennsylvania10 New York 9 Vermont9 Maine2 Slide 15 Slide 16 30:120:110:1 Slide 17 Slide 18 Slide 19 Slide 20 30:120:110:1 Slide 21 Slide 22 Slide 23 Slide 24 How can this tool improve forecasts? More objective way to estimate snowfall accumulations Uses cloud physics parameters, surface and vertical temperature data No QPF conversion required Accumulation rates can be used to indicate intensity Better indication of event duration, thus providing better guidance for advisory/warning issuance Slide 25 Slide 26