OPERATING MANUAL FOR ELECTRONICMAGNETIC BOARD

INSTALL BATTERY

1. Please slide the battery housing cover to the right to open.2. Load the battery (1.5V AA alkaline, 4 pcs)3. Close the battery housing cover.

1ST OPTION : HOW TO OPEN THE SAFE (SECURITY CODE + MASTER KEYS)

Factory code: 1 2 31. Press (*), Red Light is ON2. Enter Factory Code ( 1 2 3 )3. Press (#), Blue Light is ON with melody4. Turn a Key (or pull down a Handle) within 3 seconds to open the Door

Batterycover

MagneticLock

Led Light

Key Lock

KSG: 4500:2006ISO 9001:2008

www.salvadosafe.com

HOW TO CHANGE THE SECURITY CODE (Available min 3 Digits max 15 Digits)

During enter New Security code; the door must be open until the code registered successfully.Find (M) button on the back of the door

1. Press (M) Button, the lock sound (BEEP) and (Blue Light is ON)

2. Within 3 seconds press a new security code ex: 1 2 3 4

3. Press (#), Melody rings and (Blue Light turn OFF)Then you have registered your code successfully.

• While keeping the Door open retype your code more than once to make sure that your New Security Code entered completely

Before closing the Safe Door

• Test your new security code (do not close the door)(*) new security code registered (#) ex: (*) 1234 (#)- If (Blue Light is ON), you changed a security code successfully.- If (Red Light is ON), you failed to change a security code. Please try to change it according to the above No. 1~3.

SLEEPING MODE

In case that wrong code entered, beep sound is ON If the wrong code tried over 3 times, Red Light Is ON the lock gets paralyzed and doesn’t work for three (3) minutes;

RED Light will turn OFF,a fter 3 minutes if you press the correct security code it will operate well.

2ND OPTION : HOW TO OPEN THE SAFE ( MAGNETIC KEY + MASTER KEYS)

1. Close the silver covers to the left so the numbers will hide and the magnetic lock will appears.

2. Put a Magnetic Key on a hole of the Magnetic Lock (Blue Light is ON with sound)3. Turn the Master Key (or pull down a Handle) within 3 seconds to open the Door.

HOW TO REGISTER A MAGNETIC KEY

During registered the Magnetic Key; the door must be open until it registered successfullyFind (M) button on the back of the door

1. Press and hold down the (M) button for 2 seconds (Blue Light is ON with beep sound)2. Within 3 seconds, place the new Magnetic key on the sensor hole3. If the Magnetic Key was successfully programmed, you will hear a melody

Before closing the Safe Door

• Test your new security code (do not close the door)Place your programmed Magnetic Key on the sensor- If (Blue Light is ON), the Magnetic Key was successfully enrolled.- If (Red Light is ON), the enrollment was unsuccessful and you should repeat the programming procedure.Please try to register your Magnetic Key again according to the above No.1~3.

MagneticLock

MagneticKey

SLEEPING MODE

1. If you place the wrong Magnetic Key (un-programmed), Red Light will be on with beep sound.2. If you place the wrong Magnetic Key (un-programmed) 5 times, the lock will go into sleep mode.

After waiting 3 minutes, you should be able to attempt to open the safe with a correct enrolled Magnetic Key.

HOW TO CHANGE THE BATTERY

>> If the Blue Light is blinking with sound when you press (*) orwhen you hold the Magnetic Key -- It is the time to replace the Battery.

>> 1.5v X 4 pcs of alkaline battery

Thank You For Your Choice