PMI Dynamic Sewn LanyardThe PMI Dynamic Sewn Lanyard is intended for personal use such as fall arrest, fall prevention, and work positioning. Ideal for fall prevention when ascending or descending in rope access work. This lanyard has PMI sewn eyes on each end creating a permanent, sewn termination that is stronger than any knot. Requires carabiners for proper use.

UseUse this product only for its intended use, and within appropriate safety guidelines. The user must determine and work within an appropriate safety factor for the conditions/situations in which equipment is used. This lanyard is intended for personal use. A copy of this user instruction should remain with the equipment and should be referred to before each use. All users must read these instructions and be suitably trained by a qualified trainer before using this product.

Maintenance and CareThe strength and performance of this product may be affected by wear, abrasion, age, condition, contaminants, or other factors.

During use, apply the following guidelines:Use with appropriate additional components (connectors, shock absorber, etc), as necessary. Check to be sure this product is compatible with the other components of your system. Beware of possible abrasion where the PMI Dynamic Sewn Lanyard comes into contact with hard, abrasive, or potentially damaging surfaces. Avoid contact with chemicals, solvents or corrosive materials.Use this product with caution near moving machinery

Remove the PMI Dynamic Sewn Lanyard from service and destroy it if it does not pass inspection or if there is any doubt about its safety or serviceability. Inspection can be a subjective exercise, and should therefore always be performed by a person who has received appropriate training and is experienced in this type of equipment.

Reasons for retirement of this lanyard may include (but are not limited to):Exposure to heat, chemical or other hazardous conditionFabric shows damage, tearing, abrasion, or excessive wearThe stitching is cut, torn or excessively wornAny evidence of damage that may affect your safetyThe PMI Dynamic Sewn Lanyard is damaged or modified in such a way that it no longer complies with the standard to which it was madeLanyard has been in use for 10 years, regardless of condition

Retirement

CleaningThe PMI Dynamic Sewn Lanyard may be cleaned with clear, cool water or a mild solution of non-detergent cleanser. Hang dry away from direct sunlight. Always be sure the PMI Dynamic Sewn Lanyard is dry before putting it into storage.

InspectionFor maximum performance, inspect the PMI Dynamic Sewn Lanyard upon receipt and before each use to ensure that it is fit for use. Keep written records of all inspections.

Specifications Length Weight Color MBSSG51250 17.5 in (44.5 cm) 2.7 oz (76.5 g) Blue 22kN (5000lbf)SG51261 24.0 in (60 cm) 3.2 oz (91.3 g) Black 22kN (5000lbf)SG51251 32.5 in (82.6 cm) 3.9 oz (110.7 g) Black 22kN (5000lbf)SG51262 39.4 in (100 cm) 4.4 oz (125.5 g) Black 22kN (5000lbf)

®

Pigeon Mountain IndustriesPO Box 803 | LaFayette, GA 30728 USA

706-764-1437888-764-1437 toll freecustserv@pmirope.com

www.pmirope.com

PMI Dynamic Sewn Lanyard

This lanyard is intended for use by appropriately trained and experienced personnel. Users of this product should be suitably trained and should be competent to work in situations where their safety might depend on this product. This lanyard is expressly designed as a personal connection point, and requires two connectors for use. If in doubt about the use of this product, please contact PMI. Failure to comply with the instructions and information contained in these instructions may result in injury or death.

Proper training is required before use. These instructions are not an acceptable substitute for appropriate training by a qualified trainer. Read these user instructions and retain them as a permanent record, and maintain a copy with the PMI Dynamic Sewn Lanyard along with the product use and care record. A use and care record should be established and maintained by the purchaser or user of the PMI Dynamic Sewn Lanyard according to their needs, and should include records specific to the PMI Dynamic Sewn Lanyard. Specific information to note would include date of purchase; date put into service; maintenance and inspection records. Refer to this information before and after each use. The user of this equipment assumes all responsibilities associated with its use.

YOU COULD BE KILLED OR SERIOUSLY INJURED IF YOU DO NOT READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE USING PRODUCT. SPECIAL TRAINING AND KNOWLEDGE ARE REQUIRED TO USE THIS PRODUCT. USERS OF THIS PRODUCT SHOULD RECEIVE PROPER TRAINING FROM A QUALIFIED INSTRUCTOR PRIOR TO USE. YOU MUST THOROUGHLY READ AND UNDERSTAND ALL MANUFACTURERS INSTRUCTIONS BEFORE USE. USE AND INSPECT THIS PRODUCT ONLY IN ACCORDANCE WITH THE MANUFACTURERS INSTRUCTIONS. YOU CAN CONTACT THE MANUFACTURER AT 706-764-1437 FOR IMPORTANT SAFETY INFORMATION.

PMI Limited WarrantyPMI products are warranted to the original retail purchaser to be free from defect in material and workmanship for a period of one year. PMI will repair or replace the item without charge provided inspection at our factory discloses no misuse or alteration, which, in our judgment, has affected the condition or functioning of the product. All implied warranties imposed by law in connection with the sale of PMI products are also limited in duration to a period of one year. PMI expressly excludes and shall not be liable for any consequential damages arising out of any breach of the express or implied warranties on sales of PMI products. Because of the high risks involved in high angle rope work such as, but not limited to, rescue, rope access, caving, rappelling, rock climbing and mountaineering, no further warranties exist or are implied by PMI. Regulations issued under the Magnuson-Moss Warranty Act require us to include the following statement: some states do not allow limitations on how long an implied warranty lasts nor the excluding or limitation of incidental or consequential damages, so the above limitations may not apply to you.

Equipment Inspection Log

Item Lot#

Date in Service

Size

Date Use or Maintenance Comments Name

Additional Information

For additional information about this or other PMI products, contact us.

Pigeon Mountain Industries, Inc. PO Box 803 LaFayette, GA 30728 Toll Free: 888.764.1437Phone: 706.764.1437Fax: 800.952.3747 or 706.764.1531Email: info@pmirope.com

Web: www.pmirope.com

Warning

Equipment Inspection Log

WARNING

WARNING

WARNING