product instruction addendum to manual no. e65-76, section 9 -2 … · 2018-05-10 · product...
TRANSCRIPT
![Page 1: Product Instruction Addendum to Manual No. E65-76, Section 9 -2 … · 2018-05-10 · Product Instruction Addendum to Manual No. E65-76, Section 9 -2 . Smart Analyzer 90 - Type SMA](https://reader033.vdocuments.net/reader033/viewer/2022060217/5f0662ab7e708231d417bb5f/html5/thumbnails/1.jpg)
IM-A-SMA_Addendum_ID-53-1631_0 (Jan 2012)
Introduction
Three switches (SW5, SW6, and SW7), located on the "Input / Output" circuit board, see second photo, page 2 of this addendum, conduct sufficient current to require routine preventive maintenance. These switches, due to unusual atmospheric exposure, can develop low internal contact resistance. Contact resistance can cause heat build-up, which in turn reduces switch life. Routine exercising of the switch keeps the contacts clean and resistance free.
:
Maintenance Procedure:
Maintenance Interval: Six months and/or when the unit is Out of Service.
Tools required
The three switches are easily identifiable (second photo, page 2).
: Small screwdriver
Remove power to unit.
Verify zero voltage on L & N (Line & Neutral) in the Main Termination Chamber.
Refer to first photo, page 2 of this addendum for L1 & L2 location.
Note the switch positions 110 vs. 220 prior to maintenance in order to re-set properly later.
Rotate "cycle" switches "Back and Forth" between 110 and 220 positions, (3) times.
Re-set switches to their original required settings, (i.e. 110 or 220).
Procedure completed
Note
(reference table 6-1, page 6-4 of manual).
: Initial power up, subsequent to this procedure, must include a check of the flange block temperature and duty cycle,
Product Instruction Addendum to Manual No. E65-76, Section 9-2
Smart Analyzer 90 - Type SMA Preventive Maintenance
![Page 2: Product Instruction Addendum to Manual No. E65-76, Section 9 -2 … · 2018-05-10 · Product Instruction Addendum to Manual No. E65-76, Section 9 -2 . Smart Analyzer 90 - Type SMA](https://reader033.vdocuments.net/reader033/viewer/2022060217/5f0662ab7e708231d417bb5f/html5/thumbnails/2.jpg)
IM-A-SMA_Addendum_ID-53-1631_0 (Jan 2012)
Product Instruction Addendum to Manual No. E65-76, Section 9-2
Page 2 of 2
______________________________________________________
L1 & L2 located in terminal chamber
SW5, SW6, SW7 location