prof. dr.-ing jochen h. schiller inst. of computer science freie universität berlin germany 3.1...

Prof. Dr.-Ing Jochen H. SchillerInst. of Computer ScienceFreie Universität BerlinGermany

Prof. Dr.-Ing. Jochen H. Schiller www.jochenschiller.de MC - 2015 3.1

Motivation

SDMA, FDMA, TDMA, CDMA

Aloha, reservation schemes

Collision avoidance, MACA

Polling

Comparison

Mobile CommunicationsChapter 3: Media Access

3.2Prof. Dr.-Ing. Jochen H. Schiller www.jochenschiller.de MC - 2015

Motivation

Can we apply media access methods from fixed networks?

Example CSMA/CD-Carrier Sense Multiple Access with Collision Detection-send as soon as the medium is free, listen into the medium if a collision occurs (legacy method in IEEE 802.3)

Problems in wireless networks-signal strength decreases proportional to the square of the distance- the sender would apply CS and CD, but the collisions happen at the receiver- it might be the case that a sender cannot “hear” the collision, i.e., CD does not work- furthermore, CS might not work if, e.g., a terminal is “hidden”


Motivation - hidden and exposed terminals

Hidden terminals-A sends to B, C cannot receive A -C wants to send to B, C senses a “free” medium (CS fails)-collision at B, A cannot receive the collision (CD fails)-A is “hidden” for C

Exposed terminals-B sends to A, C wants to send to another terminal (not A or B)-C has to wait, CS signals a medium in use-but A is outside the radio range of C, therefore waiting is not necessary-C is “exposed” to B

BA C


Motivation - near and far terminals

Terminals A and B send, C receives-signal strength decreases proportional to the square of the distance- the signal of terminal B therefore drowns out A’s signal-C cannot receive A

If C for example was an arbiter for sending rights, terminal B would drown out terminal A already on the physical layer

Also severe problem for CDMA-networks - precise power control needed!

A B C


Access methods SDMA/FDMA/TDMA

SDMA (Space Division Multiple Access)-segment space into sectors, use directed antennas -cell structure

FDMA (Frequency Division Multiple Access)-assign a certain frequency to a transmission channel between a sender and a receiver-permanent (e.g., radio broadcast), slow hopping (e.g., GSM), fast hopping (FHSS, Frequency Hopping Spread Spectrum)

TDMA (Time Division Multiple Access)-assign the fixed sending frequency to a transmission channel between a sender and a receiver for a certain amount of time

The multiplexing schemes presented in chapter 2 are now used to control medium access!


FDD/FDMA - general scheme, example GSM

f

t

124

1

124

1

20 MHz

200 kHz

890.2 MHz

935.2 MHz

915 MHz

960 MHz


TDD/TDMA - general scheme, example DECT

1 2 3 11 12 1 2 3 11 12

tdownlink uplink

417 µs


Aloha/slotted aloha

Mechanism- random, distributed (no central arbiter), time-multiplex-Slotted Aloha additionally uses time-slots, sending must always start at slot boundaries

Aloha

Slotted Aloha

sender A

sender B

sender C

collision

sender A

sender B

sender C

collision

t

t


DAMA - Demand Assigned Multiple Access

Channel efficiency only 18% for Aloha, 36% for Slotted Aloha -assuming Poisson distribution for packet arrival and packet length

Reservation can increase efficiency to 80%-a sender reserves a future time-slot-sending within this reserved time-slot is possible without collision- reservation also causes higher delays- typical scheme for satellite links

Examples for reservation algorithms:-Explicit Reservation according to Roberts (Reservation-ALOHA)- Implicit Reservation (PRMA)-Reservation-TDMA


Access method DAMA: Explicit Reservation

Explicit Reservation (Reservation Aloha):- two modes:

-ALOHA mode for reservation:competition for small reservation slots, collisions possible

- reserved mode for data transmission within successful reserved slots (no collisions possible)- it is important for all stations to keep the reservation list consistent at any point in time and, therefore, all stations have to synchronize from time to time

Aloha reserved Aloha reserved Aloha reserved Aloha

collision

t


Access method DAMA: PRMA

Implicit reservation (PRMA - Packet Reservation MA):-a certain number of slots form a frame, frames are repeated-stations compete for empty slots according to the slotted aloha principle-once a station reserves a slot successfully, this slot is automatically assigned to this station in all following frames as long as the station has data to send

-competition for this slots starts again as soon as the slot was empty in the last frame

frame1

frame2

frame3

frame4

frame5

1 2 3 4 5 6 7 8 time-slot

collision at reservation attempts

A C D A B A F

A C A B A

A B A F

A B A F D

A C E E B A F Dt

ACDABA-F

ACDABA-F

AC-ABAF-

A---BAFD

ACEEBAFD

reservation


Access method DAMA: Reservation-TDMA

Reservation Time Division Multiple Access -every frame consists of N mini-slots and x data-slots-every station has its own mini-slot and can reserve up to k data-slots using this mini-slot (i.e. x = N * k).-other stations can send data in unused data-slots according to a round-robin sending scheme (best-effort traffic)

N mini-slots N * k data-slots

reservationsfor data-slots

other stations can use free data-slotsbased on a round-robin scheme

e.g. N=6, k=2


MACA - collision avoidance

MACA (Multiple Access with Collision Avoidance) uses short signaling packets for collision avoidance-RTS (request to send): a sender request the right to send from a receiver with a short RTS packet before it sends a data packet

-CTS (clear to send): the receiver grants the right to send as soon as it is ready to receive

Signaling packets contain-sender address- receiver address-packet size

Variants of this method can be found in IEEE802.11 as DFWMAC (Distributed Foundation Wireless MAC)


MACA examples

MACA avoids the problem of hidden terminals-A and C want to send to B

-A sends RTS first-C waits after receiving CTS from B

MACA avoids the problem of exposed terminals-B wants to send to A, C to another terminal

-now C does not have to wait for it, cannot receive CTS from A

A B C

RTS

CTSCTS

A B C

RTS

CTS

RTS


MACA variant: DFWMAC in IEEE802.11

idle

wait for the right to send

wait for ACK

sender receiver

packet ready to send; RTS

time-out; RTS

CTS; data

ACK

RxBusy

idle

wait fordata

RTS; RxBusy

RTS; CTS

data; ACK

time-out data; NAK

ACK: positive acknowledgementNAK: negative acknowledgement

RxBusy: receiver busy

time-out NAK;RTS


Polling mechanisms

If one terminal can be heard by all others, this “central” terminal (a.k.a. base station) can poll all other terminals according to a certain scheme-now all schemes known from fixed networks can be used (typical mainframe - terminal scenario)

Example: Randomly Addressed Polling-base station signals readiness to all mobile terminals- terminals ready to send can now transmit a random number without collision with the help of CDMA or FDMA (the random number can be seen as dynamic address)

- the base station now chooses one address for polling from the list of all random numbers (collision if two terminals choose the same address)

- the base station acknowledges correct packets and continues polling the next terminal- this cycle starts again after polling all terminals of the list


ISMA (Inhibit Sense Multiple Access)

Current state of the medium is signaled via a “busy tone”- the base station signals on the downlink (base station to terminals) if the medium is free or not - terminals must not send if the medium is busy - terminals can access the medium as soon as the busy tone stops- the base station signals collisions and successful transmissions via the busy tone and acknowledgements, respectively (media access is not coordinated within this approach)

-mechanism used, e.g., for CDPD (USA, integrated into AMPS)


Access method CDMA

CDMA (Code Division Multiple Access)-all terminals send on the same frequency probably at the same time and can use the whole bandwidth of the transmission channel

-each sender has a unique random number, the sender XORs the signal with this random number- the receiver can “tune” into this signal if it knows the pseudo random number, tuning is done via a correlation function

Disadvantages:-higher complexity of a receiver (receiver cannot just listen into the medium and start receiving if there is a signal)

-all signals should have the same strength at a receiver

Advantages: -all terminals can use the same frequency, no planning needed-huge code space (e.g. 232) compared to frequency space- interferences (e.g. white noise) is not coded- forward error correction and encryption can be easily integrated


CDMA in theory

Sender A -sends Ad = 1, key Ak = 010011 (assign: “0”= -1, “1”= +1)-sending signal As = Ad * Ak = (-1, +1, -1, -1, +1, +1)

Sender B-sends Bd = 0, key Bk = 110101 (assign: “0”= -1, “1”= +1)-sending signal Bs = Bd * Bk = (-1, -1, +1, -1, +1, -1)

Both signals superimpose in space - interference neglected (noise etc.)-As + Bs = (-2, 0, 0, -2, +2, 0)

Receiver wants to receive signal from sender A-apply key Ak bitwise (inner product)

-Ae = (-2, 0, 0, -2, +2, 0) Ak = 2 + 0 + 0 + 2 + 2 + 0 = 6- result greater than 0, therefore, original bit was “1”

- receiving B-Be = (-2, 0, 0, -2, +2, 0) Bk = -2 + 0 + 0 - 2 - 2 + 0 = -6, i.e. “0”


CDMA on signal level I

data A

key A

signal A

data key

key sequence A

Real systems use much longer keys resulting in a larger distance between single code words in code space.

1 0 1

10 0 1 0 0 1 0 0 0 1 0 1 1 0 0 1 1

01 1 0 1 1 1 0 0 0 1 0 0 0 1 1 0 0

Ad

Ak

As


CDMA on signal level II

signal A

data B

key B

keysequence B

signal B

As + Bs

data key

1 0 0

00 0 1 1 0 1 0 1 0 0 0 0 1 0 1 1 1

11 1 0 0 1 1 0 1 0 0 0 0 1 0 1 1 1

Bd

Bk

Bs

As


CDMA on signal level III

Ak

(As + Bs) * Ak

integratoroutput

comparatoroutput

As + Bs

data A

1 0 1

1 0 1 Ad


CDMA on signal level IV

integratoroutput

comparatoroutput

Bk

(As + Bs) * Bk

As + Bs

data B

1 0 0

1 0 0 Bd


CDMA on signal level V

comparatoroutput

wrong key K

integratoroutput

(As + Bs) * K

As + Bs

(0) (0) ?


SAMA - Spread Aloha Multiple Access

Aloha has only a very low efficiency, CDMA needs complex receivers to be able to receive different senders with individual codes at the same time Idea: use spread spectrum with only one single code (chipping sequence) for spreading for all senders accessing according to aloha

1sender A0sender B

0

1

t

narrowband

send for a shorter periodwith higher power

spread the signal e.g. using the chipping sequence 110101 („CDMA without CD“)

Problem: find a chipping sequence with good characteristics

1

1

collision

3.26

Comparison SDMA/TDMA/FDMA/CDMA

Approach SDMA TDMA FDMA CDMA Idea segment space into

cells/sectors segment sending time into disjoint time-slots, demand driven or fixed patterns

segment the frequency band into disjoint sub-bands

spread the spectrum using orthogonal codes

Terminals only one terminal can be active in one cell/one sector

all terminals are active for short periods of time on the same frequency

every terminal has its own frequency, uninterrupted

all terminals can be active at the same place at the same moment, uninterrupted

Signal separation

cell structure, directed antennas

synchronization in the time domain

filtering in the frequency domain

code plus special receivers

Advantages very simple, increases capacity per km²

established, fully digital, flexible

simple, established, robust

flexible, less frequency planning needed, soft handover

Disadvantages inflexible, antennas typically fixed

guard space needed (multipath propagation), synchronization difficult

inflexible, frequencies are a scarce resource

complex receivers, needs more complicated power control for senders

Comment only in combination with TDMA, FDMA or CDMA useful

standard in fixed networks, together with FDMA/SDMA used in many mobile networks

typically combined with TDMA (frequency hopping patterns) and SDMA (frequency reuse)

higher complexity, lowered expectations; integrated with TDMA/FDMA

Prof. Dr.-Ing. Jochen H. Schiller www.jochenschiller.de MC - 2015

prof. dr.-ing jochen h. schiller inst. of computer science freie universität berlin germany 3.1...

Documents

ing jochen

signal c

c exposed terminals

medium access

signal of terminal b

c senses

necessary c

terminals terminals