quick start guide - controlbyweb · © 2015 xytronix research and design, inc. quick start guide...
TRANSCRIPT
© 2015 Xytronix Research and Design, Inc.
Quick Start GuideBASIC SETUP STEPS:
FACTORY DEFAULT SETTINGS:
IP Address: 192.168.1.2Subnet Mask: 255.255.255.0Control Web Address: http://192.168.1.2Setup Web Address: http://192.168.1.2/setup.htmlSetup Username: adminSetup Password: webrelay (all lower case)Control Password: no password set
Full Users Manual may be downloaded from: http://www.ControlByWeb.comFor technical support, email questions to: [email protected]
Rev 1.0
a division of Xytronix Research & Design, Inc. Nibley, Utah, USA
*When operating more than one valve at a time make sure you power the SmartStorm with a large enough transformer to support multiple valve operation.
Warning: Only use the 24VAC terminals for powering SmartStorm!
Connect the module to power (use 24VAC terminals for only powering device) and to a network.Set up a computer on the same network as the module. To do this, set the IP address of the computer to 192.168.1.50 with a netmask of 255.255.255.0.Configure the module using a web browser by typing the following into the address bar of a web browser: http://192.168.1.2/setup.html Login to the setup pages using the default username: admin, and default password: webrelay (all lower case).Set the permanent IP address in the Network tab.Restart the module (remove power, re-apply power).After restarting the module, set the computer back to its original settings and access the module at its new IP address.
1.
2.
3.
4.
5.6.
*