r section 1: removing the stock vacuum line...
TRANSCRIPT
1000 SEVILLE RD. WADSWORTH, OH 44281 1.800.924.5172 WWW.ECSTUNING.COM PAGE 1 OF 4
BMW N54 VACUUM LINE RELOCATION KIT INSTALLATION ES#4040572R
© 2020 ECS TUNING
Step 1 • Remove the stock vacuum line assembly from the engine bay. There are three connection points:- The forward connection is located
just behind the alternator (RED inset photo below). Space is tight around this connection, patience is key. To release this fitting you need to squeeze the two knurled sides of the locking ring inward (reference the illustrations on the right).
- The rearward connection is located just below the wiper cowl (BLUE inset photo below). Push the white locking tab inward on the connector to release this fitting.
- Disconnect the rubber hose which runs from the vacuum line assembly to the hose connection on the LH strut tower (YELLOWYELLOW inset photo below). This hose supplies engine vacuum to the exhaust valve located on the muffler.
Section 1: Removing the Stock Vacuum Line Assembly
Step 1
Tab TabTab Tab
1000 SEVILLE RD. WADSWORTH, OH 44281 1.800.924.5172 WWW.ECSTUNING.COM PAGE 2 OF 4
BMW N54 VACUUM LINE RELOCATION KIT INSTALLATION ES#4040572R
© 2020 ECS TUNING
Step 1 • Carefully cut the vacuum line off of two 90º fittings. These fittings need to be transferred to the new silicone hose (see next page).
- Be very careful here to avoid cutting into the plastic barbs on the old fittings.
Section 2: Installing the New Vacuum Line Relocation Kit
Step 1
1000 SEVILLE RD. WADSWORTH, OH 44281 1.800.924.5172 WWW.ECSTUNING.COM PAGE 3 OF 4
BMW N54 VACUUM LINE RELOCATION KIT INSTALLATION ES#4040572R
© 2020 ECS TUNING
Step 2 • Transfer the two fittings over to the new silicone hose set as shown below.• Route the new hose set under the intake manifold and behind the throttle body (BLACK boxes below).• Connect the forward and rearward fittings in the engine bay (RED boxes below).• Connect the hoses from the vacuum reservoirs to the billet adapter. Use the supplied vacuum hose to
connect the exhaust vacuum valve line to the billet adapter (GREEN boxes below).• Tighten all of the hose clamps until snug.
Section 2: Installing the New Vacuum Line Relocation Kit
Step 2To: Connection
under wiper cowl
To connection behind alternator
Route this section of hose under the
intake manifold
To vacuum reservoir
hoses
To: Exhaust valve vacuum hose
Route this section of hose behind
the throttle body
1000 SEVILLE RD. WADSWORTH, OH 44281 1.800.924.5172 WWW.ECSTUNING.COM PAGE 4 OF 4
BMW N54 VACUUM LINE RELOCATION KIT INSTALLATION ES#4040572R
© 2020 ECS TUNING
Proper service and repair procedures are vital to the safe, reliable operation of all motor vehicles as well as the personal safety of those performing the repairs. Standard safety procedures and precautions (including use of safety goggles and proper tools and equipment) should be followed at all times to eliminate the possibility of personal injury or improper service which could damage the vehicle or compromise its safety.
Thank you for purchasing your new ECS TuningN54 Vacuum Line Relocation Kit, we appreciate your business!