relay module mpr-2s - ampio smart home...module mpr-2s is a component of the ampio smart home...

MODULE DESCRIPTION www.ampio.com.pl Relay module MPR-2s ver 1.1, 14.02.2017 Copyright © 2016 Automatyka-Control. All rights reserved. Purpose Module MPR-2s is a component of the Ampio Smart Home system. It has two independent relay outputs. The module has an LED indicator. On the front of the module are signalling LED indicators. Green LED indicates communication over CAN-Bus: one regular flash every 1 sec. - CAN-Bus communication in order two regular flashes every 1 sec. - module is not receiving information from other iDom modules three regular flashes every 1 sec. - module cannot send information to CAN-Bus The remaining red LED indicators signal the status of particular outputs of the module: indicator on - relay output's contacts on indicator off - relay output's contacts off Examples of application: lighting control, propulsion systems control, any devices with a maximum power not exceeding 230V, whose energy consumption does not exceed 6A. Module steering is done via CAN-Bus. Required voltage for the module is 12V DC. Two outputs of the device enable independent steering of two receivers. Each output is and independent relay contact, so it is possible to connect them in such a way that one section controls 230V AC voltage, and the other one 12V DC, etc. Module programming is done through a special programmer available to authorised installers, as well as through the iDomKonfigurator programme. Thanks to the programme, the ways in which modules should react to inputs and other information from the CAN bus can be configured. Technical data: Module voltage supply 12V DC Number of relay outputs 2 Output current-carrying capacity (OUT1...8) 16A Maximum switchable voltage 230V Number of module inputs none 1-Wire connector none Dimensions : width 35mm heigh 65mm depth 120mm (with plugs)

Upload: others

Post on 23-Sep-2020

1 views

Category:

Documents

0 download

Report

Download

Embed Size (px):

TRANSCRIPT

Page 1: Relay module MPR-2s - Ampio Smart Home...Module MPR-2s is a component of the Ampio Smart Home system. It has two independent relay outputs. The module has an LED indicator. On the

MODULE DESCRIPTION

www.ampio.com.pl

Relay module MPR-2s

PurposeModule MPR-2s is a component of the Ampio Smart Home system. It has two independent relay outputs. The module has an LED indicator.

On the front of the module are signalling LED indicators. Green LED indicates communication over CAN-Bus: one regular flash every 1 sec. - CAN-Bus communication in order two regular flashes every 1 sec. - module is not receiving information from other iDom modules three regular flashes every 1 sec. - module cannot send information to CAN-Bus

The remaining red LED indicators signal the status of particular outputs of the module:

indicator on - relay output's contacts on indicator off - relay output's contacts off

Examples of application: lighting control, propulsion systems control, any devices with a maximum power not exceeding 230V, whose energy consumption does not exceed 6A.

Module steering is done via CAN-Bus. Required voltage for the module is 12V DC. Two outputs of the device enable independent steering of two receivers. Each output is and independent relay contact, so it is possible to connect them in such a way that one section controls 230V AC voltage, and the other one 12V DC, etc. Module programming is done through a special programmer available to authorised installers, as well as through the iDomKonfigurator programme. Thanks to the programme, the ways in which modules should react to inputs and other information from the CAN bus can be configured.

Technical data: Module voltage supply 12V DCNumber of relay outputs 2Output current-carrying capacity (OUT1...8) 16AMaximum switchable voltage 230VNumber of module inputs none1-Wire connector noneDimensions : width 35mmheigh 65mmdepth 120mm (with plugs)