ROAD DESIGN PRESENTATION STANDARDS

DP003 – GENERAL CONSTRUCTION K Net Number: 13555433 Document Revision: 5 Document Date: 21 January 2014

Document Amendment Record

Master Specification Revision 5 2

Document Amendment Record Rev Change Description Date Author Checked Authorised

1 Initial Issue 29 July 2009 Anthony Crotty Natasha Stone Noel O’Callaghan

2 General review of text and example drawings 17 March 2010

John Hastie Alison Freer Noel O’Callaghan

3 General review of text and example drawings 23 December 2011

John Hastie Alison Freer Jeremy Champion Noel O’Callaghan

4 Culvert label and legend updated 15 February 2013 Natasha Stone Jeremy Champion Noel O’Callaghan

5 Note 1 amended, Long/Lat added 21 January 2014 Natasha Stone Jeremy Champion Noel O’Callaghan

Document Management This document is the Property of the Department of Planning Transport and Infrastructure (DPTI) and contains information that is confidential to DPTI. It must not be copied or reproduced in any way without the written consent of DPTI. This is a controlled document and it will be updated and reissued as approved changes are made. To be read in conjunction with CAD Manual & Presentation Guidelines DP001 (Master Specification PC-EDM7)

DP003 GENERAL CONSTRUCTION

Master Specification Revision 5 3

DP003 GENERAL CONSTRUCTION

1 Purpose 1.1 The ‘General Construction’ drawing is used to show the construction requirements within the scope

of a project.

1.2 For examples of this standard see attached drawings.

2 Content 2.1 Layers to be shown as per the DPTI Layer Matrix (DP 001)

2.2 The following CAD entities are required:

a) All information in DP 001 - General Requirements.

b) Text describing features to be removed, reinstated, relocated, replaced or abandoned. (layer = “D-ENHA-General Notes”) (Paper Space text height = 2.5mm)

c) Text describing features to be installed. Include cross references to installation details if appropriate. (layer = “D-ENHA-General Notes”) (Paper Space text height = 2.5mm)

d) Text describing size and type of existing services as supplied in the survey.

(layer = “S-GAS-Service Label”, “S-WATR- Service Label”, “S-SEWR- Service Label”, “S-COMM- Service Label”, “S-ELEC- Service Label” ) (Paper Space text height = 2.5mm)

e) Text and symbols showing new services information (if supplied). (Paper Space text height = 2.5mm)

f) Dimensions to assist interpretation of the design. (layer = “D-ENHA-Dimensions”)

g) Text describing components of any designed safety barrier including lengths and definitions of elements, post spacings and end treatments (layer = “D-ENHA-General Notes”) (paper space text height = 2.5mm).

2.3 Survey on the General Construction Drawing shall be untrimmed. (ie survey detail should extend across the design area)