s-200 welded steel pipe (awwa c200) (u.s.) · 2020. 10. 9. · (awwa c200) heat shrink sleeve...

2
S-200 WELDED STEEL PIPE (AWWA C200) (U.S.)

Upload: others

Post on 29-Jan-2021

22 views

Category:

Documents


1 download

TRANSCRIPT

  • S-200 WELDED STEEL PIPE (AWWA C200) (U.S.)

  • S-200 WELDED STEEL PIPE(AWWA C200)

    Heat Shrink Sleeve

    Welded Steel Cylinder Inside Joint SpaceCement Mortar Place in Field

    n

    JOINT CLOSURE:TPG Pressure offers two primary types of steel pipe joints:

    Rubber Gasket Joint (up to 48"/1200 mm)

    n Welded Joint (all sizes)The Rubber Gasket joint is TPG Pressure’s standard joint for small diameter steelpipe. For larger diameter pipe, TPG Pressure uses the lap-welded joint.

    RUBBER GASKET JOINT:

    Spigot Ring Bell End Polyurethane Coating

    GasketCentrifugally Cast Cement Mortar Lining

    Mastic Filler Heat Shrink Sleeve

    Joint Pushed

    Home

    Welded Steel Cylinder Gasket Inside Joint Space Mortar Placed in Field

    Welded Steel Cylinder

    Mastic Filter Dielectric Coating

    Inside Joint Space Mortar Placed in Field

    Cement Mortar Lining

    Heat ShrinkSleeve

    LAP-WELDED JOINT:

    Spigot End Bell End Polyurethane Coating

    Centrifugally Cast Cement Mortar Lining

    Heat Shrink Sleeve

    Joint Pushed

    Home

    Welded Steel Cylinder

    Thompson Pipe Group Pressure Welded Steel Pipe is manufactured per AWWA C200. The pipe is available in diameters from 32” (800 mm) O.D. up to 124” (3150 mm) O.D. It is mortar-lined in accordance with AWWA C205 for maximum durability and is available with polyurethane(AWWA C222) or tape (AWWA C214) coating.

    Welded Steel Pipe is designed for internal pressure using the Hoop Stress Formula. For external loads and as a flexible pipe, steel pipe is designed using the Iowa Equation to estimate and limit pipe deflection. For handling purposes, minimum wall thickness should be considered to ensure limited deflection and damage during pipe handling.

    The basis of design provides a safety factor comparable to other waterworks pipe materials for normal service conditions and surge or water hammer. The stress in the steel components at working pressure is limited to one half the yield strength of the steel.

    1003 MacArthur Blvd | Grand Prairie, TX 75050 | www.thompsonpipegroup.com | 972.262.3600

    Gasket

    Inside Joint Space Cement Mortar Placed in Field