safety walk-manuel fernandez
TRANSCRIPT
SAFETY WALKManuel Fernandez
OMGT 5403
Machining Lab
I had an opportunity to conduct a hazard zone inspection of a machining lab at my work.
The adjunct instructor allowed me to view and take pictures of common workplace activities.
For the walk through, I only included yes statements from the checklist.
While operating a drill press or other machining equipment, the worker did have to bend his neck and back with no support
While operating the mill or lathe, the worker routinely had to turn the axis handles in a repetitive motion.
While operating the vise, the worker has to use his hand to loosen the grip.
Safety Hazards
While walking the floor, other safety hazards were identified.
There is no guard on the grinder and there is more than 1/8” gap between the wheel and the platform
Safety Hazards
While walking the floor, other safety hazards were identified.
There is no guard on the chuck lathe
Safety Hazards
While walking the floor, other safety hazards were identified.
There is no label on this bottle.
Safety Hazards
While walking the floor, other safety hazards were identified.
There is oil on the floor.
Safety Hazards
While walking the floor, other safety hazards were identified.
There are no secondary traps for containers of oil and these flammable liquids should be stored in a locker