safety_belt_system_b_pillar_5d.pdf
TRANSCRIPT
Safety Belt System - Front Safety Belt
Retractor—5-DoorFiesta 2002.25 (11/2001-09/2008)
Print Report An Error
Removal and Installation
Removal
1. Detach the door opening weatherstrips from the B-
pillar.
2. Move the safety belt shoulder height adjuster to its
lowest position.
3. NOTE: Hold the safety belt webbing when detaching
the safety belt lower anchor from the floor panel.
Detach the safety belt lower anchor from the floor
panel.
Remove the retaining bolt and spacer from the
anchor plate.
4. Remove the B-pillar upper trim panel.
1. Remove the screw cover.
2. Remove the retaining screw.
3. Detach the retaining clips from the B-pillar.
Feed the safety belt webbing through the B-
pillar upper trim panel.
5. Remove the B-pillar lower trim panel.
Detach the retaining clips.
6. Remove the cowl side trim panel.
6. Remove the cowl side trim panel.
Detach the retaining clips.
7. CAUTION: The bolt securing the safety belt
anchor is held captive by a paper washer. The bolt,
spacer and paper washer must remain on the safety
belt anchor at all times when the safety belt is
detached or removed.
Detach the safety belt upper anchor from the safety
belt shoulder height adjuster.
8. Detach the guide loop from the B-pillar.
1. Rotate the guide clockwise.
2. Slide the guide downwards.
9. CAUTION: The safety belt retractor retaining
bolt must only be used five times.
NOTE: After removal, stamp the safety belt
retractor retaining bolt with a center punch to
indicate usage.
Remove the front safety belt retractor.
1. Remove the bolt.
2. Lift the retractor to detach the locating tang.
Installation
1. CAUTIONS:
Make sure the safety belt retractor locating
tang is correctly located.
The safety belt retractor retaining bolt must
only be used five times, inspect the markings on the
retaining bolt and install a new retaining bolt if
necessary.
NOTE: Make sure the safety belt shoulder height
adjuster locking control is correctly located on the
safety belt shoulder height adjuster.
To install, reverse the removal procedure.