segmented turning...place 45 deg. cut pieces edge to edge, using masking tape to hold secure while...
TRANSCRIPT
-
Segmented TurningBy Jerry Holbrook
1
-
Glue up center piece using contrast pieces of wood
2
-
Select piece of wood to be fitted and glued around centerpiece
3
-
Run selected piece thru jointer to true up faces
4
-
Plane selected piece to desired uniform thickness
5
-
Set saw blade cut to 45 Deg.
6
-
Using center piece, mark cut for 45 deg. cuts
7
-
Cut 4 pieces for exact fit around center piece
8
-
Place 45 deg. Cut pieces edge to edge, using masking tape to hold secure while glueing to center piece and clamp
9
-
Mark off a circle equal to a 4” forstnerbit on top of block so so a cylinder can be cut on the band saw.
10
-
Cut cylinder
11
-
Glue (2) blocks of 7” square contrasting color woods together
12
-
Drill 4” dia. Hole in center of glued contrasting blocks.
13
-
Cylinder and contrasting block glue up.
14
-
Mount cylinder in lathe and turn to fit hole in contrasting block glue-up.
15
-
Glue pieces together and remount on lathe. Set back cylinder from face to receive chuck for turning.
16
-
Turn desired shape and saw top off leaving a tenon for reattaching to the lathe at a later point
17
-
Cut pieces
18
-
Turn inside of top and turn edge to fit bottom.
19
-
Turn base leaving edge room for top to fit.
20
-
Firmly tape top to bottom & complete turning of box top.
21
-
Prepare to finish pieces
22
-
Finish top and bottom pieces
23
-
Completed Lidded bowl
24