1101 McKinley Street • Anoka, Minnesota 55303 Phone: (763) 786-6682 • Fax: (763)786-2167 www.poly-cam.com

Series 730 Transition for PVC/HDPE

Fitting DescriptionGeneral – The transition fitting is constructed out of PVC material, Epoxy coated Carbon Steel, and high density polyethylene (HDPE) 3408 pipe. The PVC and HDPE materials are joined together by hydraulically pressing the HDPE pipe into the Epoxy coated carbon steel coupling. The coupling portion of the transition fitting is machined with our multi-level patented barb system that provides a leak free radial compressed joint. The high density polyethylene and PVC portions of the transition fitting are cut to a specific length and is pressed into the coupling

DimensionsSee Poly-Cam, Inc. product dimension sheet provided separately.

System PerformanceThe transition fitting is designed to handle the pressure rating of the HDPE pipe with a 2:1 safety factor at 73.40 degrees Fahrenheit with a minimum 50 year design life.

Quality AssuranceThe transition fitting shall be manufactured by Poly-Cam, Inc. Poly-Cam, Inc. shall provide quality assurance with regards to proper installation, compatibility, performance, and acceptance. Transition joint meets or exceeds the requirements of ASTM D2513 Category 3.

WarrantyWarranty period is one year after date of substantial completion of installation.

Materials SpecificationsCarbon steel coupling – The coupling is manufactured out of A53 grade carbon steel pipe.

The epoxy coating (IF 194T Red Iron Oxide) is fusion bonded to the metal. It has approvalsNSF 61, FDA 175.300, AWWA C116-01, C213-01, UL 262 and FM 1120/1130The carbon steel epoxy POLY-CAM threaded transition fitting complies with AWWA and NSF 61 material requirements.

PVC Pipe conforms to ASTM D-1785 in sizes .75” through 24” inch. The material used in the manufacture of pipe shall be domestically produced rigid Polyvinyl Chloride (PVC) compound, Type 1 Grade I, with a Cell Classification of 12454 as defined in ASTM D1784.  Poly-cam manufacture it transition with Schedule 40 and 80, SDR21 and 26.

High Density Polyethylene – The transition fitting is constructed with a 3408 high density polyethylene pipe (cell class 345454c) that classified according to ASTM D 3350.

InstallationHDPE pipe endInstall transition fitting so as to comply with the pipe manufacturerʼs recommended procedures. All field welds shall be accomplished in accordance with Plastic Pipe Instituteʼs welding procedure for butt fusion or electro fusion.

PVC couplingInstall the PVC coupling so as to comply with the pipe manufacturerʼs recommended procedures for solvent cement.

Harvey Company MP-6 Multi-Purpose Clear Cement is a medium bodied, medium set multi-purpose cement designed for use on PVC, CPVC and ABS pipe and fittings: Schedule 40 & 80, Types I & II, up to 6 inches. For potable water, pressure pipe, gas, and conduit, drain waste and vent pipe. Flows freely and provides a thick layer of cement on the pipe and loose fitting joints. Apply at temperatures 40°F to 100°F. Meets ASTM D-2564.