Setting up windows 2000 DHCP Server for 3300 ICP Operation

1. From the start menu select Programs / Administrative Tools / DHCP

2. Right Click on server address in the Tree window and select New Scope

3. When the New Scope Wizard window appears, click on Next.

4. Enter a name and description for the new scope.

5. Enter the IP address range of the new scope.

6. Click on Next in this window and again on the Add Exclusions window and the Lease Duration window.

7. On the Configure DHCP Options window select the No, I will configure these options later button and click on Next and then Finish.

8. To add the user-assigned options, right click on the server address in the Tree window and select Set Predefined Options.

9. Click on Add.

10. Enter the Name, Data type, and code for the user defined options as follows

11. To configure the Server options, i.e. those options that apply to all scopes, right click on the server options folder in the Tree window and select Configure Options

12. Tick those options required i.e. 128, 129, 130, 132 and 133, and enter the correct values.

128 = TFTP server address (IP address of RTC card)129 = RTC card IP address130 = MITEL IP PHONE132 = VLAN ID 0x2 (hex value)133 = Priority 0x6 (hex value)

Click on Apply.

The Server Options window should look like this:

13. To add the scope options, i.e. those options that only apply to an individual scope, open the tree for the scope and right click on the Scope Options folder.

14. Select those options that apply to the scope only (example 003.) Enter the correct value and click Apply.

003 = Router address and should be the default gateway address for the scope.

The options window should now look like this:

15. To activate the new scope, right click on the scope folder in the Tree window and select Activate

The red dot on the scope folder should go green.